Quick Start Instructions

ManualsBrandsAlimed ManualsComputers & AccessoriesWireless Transmitting and Receiving Device

Wireless fully sealed Pad Alarm (Sensor Pad Transmitter) 830208

Quick Start Instructions (V4)

This Sensor Pad Transmitter (SPT) is a miniaturization wireless fall monitor for connecting

to a Wireless bed/chair Sensor Pads installed in bed, chair, wheelchair to configure a quite

wireless fall alarm. It does not need an additional monitor. When a resident gets up, the

wireless signal send to the door light Alarm, nurse call receiver and pager to alert

caregiver.

1. Record information on label

Before using a SPT, write its information on its label with an indelible marker first

(refer to below example),

2. Wake up Sensor Pad Transmitter

SPT is in sleep mode during shipping and store period. For a brand new SPT (not

programming to any device before), you will need to wake up it before programming

it to any device.

Wake up SPT by pressing and holding the Button (more than 5 seconds) on the SPT

until you see light is lighting.

Button

103 Bed1

103- Room number

Bed1- location it will be installed

Summary of content (5 pages)

PAGE 1
Wireless fully sealed Pad Alarm (Sensor Pad Transmitter) Quick Start Instructions (V4) 830208 This Sensor Pad Transmitter (SPT) is a miniaturization wireless fall monitor for connecting to a Wireless bed/chair Sensor Pads installed in bed, chair, wheelchair to configure a quite wireless fall alarm. It does not need an additional monitor. When a resident gets up, the wireless signal send to the door light Alarm, nurse call receiver and pager to alert caregiver. 1.
PAGE 2
Optional receiving devices and alarm notification - - - Wireless Nurse Call Receiver - caregivers can be notified at the nurse call station.
PAGE 3
RECORD IN USE DATE AND THE EXPIRATION DATA ON SENSOR PAD THE EXPIRATION DATA OF SENSOR PAD = PAD USABLE LIFE + IN USE DATE THE EXPIRATION DATA OF PAD TRANSMITER = 24 MONTHS + IN USE DATE 4. Setting delay time There are optional alarm delay of 0, 2, 4 seconds on SPT (bed/chair Sensor Pad Transmitter only) to reduce false alarms.
PAGE 4
signal a successful received by the programed receiving devices. c. The programed receiving devices will beeps/ Vibration and Room number/Location /Device number corresponding to the wireless transmitting device will be flashing, alerts caregivers that someone is getting up from a bed, a chair or approaching an exit or need help. d. Press button on receiving device to silence alarm. 6.
PAGE 5
FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.