Users Manual

ManualsBrandsAlign Technology ManualsElectronicsWiFi Module

WiFi M.2 Module 5GHz 802.11ac/ an/ a

Part Number: WifiM

V1.0

DESCRIPTION

WifiM is a 11ac 5GHz WiFi M.2 Module based on Mediatek MT7615 which is a WiFi

Mini PCIe single chip which supports 1733 Mbps PHY rate. It fully complies with IEEE

802.11ac and IEEE 802.11 an standards, offering feature-rich wireless connectivity at

high standards, and delivering reliable, cost-effective throughput from an extended

distance.

Optimized RF architecture and baseband algorithms provide superb performance and

low power consumption. Intelligent MAC design deploys a high efficient offload

engine and hardware data processing accelerators which completely offloads Wi-Fi

task of the host processor. MT7615 is designed to support standard based features in

the areas of security, quality of service and international regulations, giving end users

the greatest performance any time and in any circumstance.

With the advent of 802.11ac, multiuser MIMO (MU-MIMO) is defined. MT7615

supports MU-MIMO with different configurations.

Summary of content (6 pages)

PAGE 1
WiFi M.2 Module 5GHz 802.11ac/ an/ a Part Number: WifiM V1.0 DESCRIPTION WifiM is a 11ac 5GHz WiFi M.2 Module based on Mediatek MT7615 which is a WiFi Mini PCIe single chip which supports 1733 Mbps PHY rate. It fully complies with IEEE 802.11ac and IEEE 802.11 an standards, offering feature-rich wireless connectivity at high standards, and delivering reliable, cost-effective throughput from an extended distance.
PAGE 2
MT7615 Block Diagram Features:  Supports 4x4 4SS 11ac wave2 MU-MIMO  MU-MIMO configurations of  4 users: 4*1ss  Supports 20,40, 80Mhz channels  Embedded ARM Cortex R4 processor for full host CPU offload  Embedded 32-bit RISC microprocessor  iNIC Gen2 with full Wi-Fi offload  Highly integrated RF with 40nm low power process  4T4R with support of up to 1733Mbps PHY rate  Noise mitigation:  Supports background scan function for fast channel switching  Supports spectrum analysis for non-Wi-Fi s
PAGE 3
Specification: Form Factor M.2 3042 vesrion Standards Wireless: IEEE 802.11ac/an (4Tx4R) IEEE 802.11ac 1733Mbps@TX/RX IEEE 802.11a/n 600Mbps@TX/RX Data Rate IEEE 802.11a 108Mbps IEEE 802.11ac up to 1733Mbps 11a: 16.26dBm +/- 1.5dbm @ 54Mbps 11a/n:16.96dBm +/- 1.5dbm @ MCS7.HT20, 17.19dbm@MCS7,HT40 Output Power 11ac VHT20: 16.96+/-1.5dBm@MCS8 11ac VHT40: 17.19+/-1.5dBm@MCS9 11ac VHT80: 17.87+/-1.
PAGE 4
Dimension (mil [mm]) Top pins Bottom pins 4
PAGE 5
Federal Communications Commission Statement This device complies with FCC Rules Part 15. Operation is subject to the following two conditions: • This device may not cause harmful interference. • This device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the Federal Communications Commission (FCC) rules.
PAGE 6
separation distance of at least 20 cm from all persons and must not be co‐located or operating in conjunction with any other antenna or transmitter. FCC Label Instructions: The outside of final products that contains this module device must display a label referring to the enclosed module. This exterior label can use wording such as: “Contains Transmitter Module FCC ID:2ARGX‐WIFIM”,or “Contains FCC ID: 2ARGX‐WIFIM”, Any similar wording that expresses the same meaning may be used.