Quick Start Guide

– 1 –
Install the AP
a. Install it on the Wall
1. Rotate the bracket onto the T-bar of the ceiling.
2. Push the AP toward the bracket until it snaps into place.
Connect Cables
1. Connect the external cable to the WAN/POE port.
2. Connect the local LAN switch or computer cable to the LAN port.
1
2
1.
AP4220 access point
2.
3. One pack of screws
2
4
3
1
Quick Start Guide
2. Push the AP toward the bracket until it snaps into place.
One mounting bracket
4
.
Package Contents
150200002019H R04
2
Mode 2: First insert the mounting bracket into the AP then insert the
Docume
ntation—
Quick Start Guide
(this document
),
Warning:
For indoor use only. The access point and all
1. Fix two screws on the wall and 110 mm apart.
2. Slide the AP’S wall mounting slots down onto the screws so
b. Install it on the Ceiling T-Bar
d. Install it on the Ceiling Bracket
Mode 1: The hole on the back of the access point is threaded into the
cable tie, and secured to the water pipe at the top.
connected cables are not suitable for outdoor use.
Certificate and Warranty card
that the unit is secure.
at the top position.
1. Use the included screws to attach the mounting bracket to the wall.
c. Install it with Cable Ties (with or without bracket)
AP4220 Wireless Access Point