Instruction Manual

Alcatel-Lucent Enterprise
OAW-AP1361，OAW-AP1362 and OAW-
AP1361D Regulatory Compliance and
Safety Information
xxxxxx-xx Rev. A
*XXXXXX-XX Rev. A*
enterprise.alcatel-lucent.com
Alcatel-Lucent and the Alcatel-Lucent Enterprise logo are trademarks of
Alcatel-Lucent. To view other trademarks used by affiliated companies of
ALE Holding, visit: enterprise.alcatel-lucent.com/trademarks. All other
trademarks are the property of their respective owners. The information
presented is subject to ALE without notice. Neither ALE Holding nor any of
its affiliates assumes any responsibility for inaccuracies contained herein.
(2019)
◼ Introduction
This document contains domestic and international regulatory
compliance information for the access point OAW-AP1361, OAW-
AP1362 and OAW-AP1361D. To ensure that this device complies
with the regulatory standards for your region, please refer to the
content below.
FCC Part 15:
This product has been tested and found to comply with the limits
for a Class A digital device pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in
a commercial environment. This product generates, uses, and
can radiate radio frequency energy and, if not installed and used
in accordance with the manufacturer’s instruction manual, may
cause harmful interference with radio communications.
Operation of this product in a residential area is likely to cause
harmful interference, in which case you will be required to
correct the interference at your own expense.
These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generate, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one of the
following measures:
⚫ Reorient or relocate the receiving antenna.
⚫ Increase the separation between the equipment and
receiver.
⚫ Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
⚫ Consult the dealer or an experienced radio/TV technician
for help.
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions:
1) This device may not cause harmful interference.
2) This device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to
operate the equipment.
This equipment complies with FCC RF radiation exposure limits
set forth for an uncontrolled environment. This device and its
antenna must not be co-located or operating in conjunction with
any other antenna or transmitter.
This device complies with FCC and Industry Canada radiation
exposure limits set forth for general population.
This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
RF exposure warning
This equipment complies with FCC radiation exposure limits set
forth for an uncontrolled environment.
This product may not be collocated or operated in conjunction
with any other antenna or transmitter
This equipment must be installed and operated in accordance
with provided instructions and the antenna(s) used for this
transmitter must be installed to provide a separation distance of
at least 30 cm from all persons and must not be collocated or
operating in conjunction with any other antenna or transmitter.
California Proposition 65 Warning
WARNING: This product contains chemicals known to the
State of California to cause cancer and birth defects or
other reproductive harm.
For EU
ALE USA Inc., hereby declares that these models are compliant
with the essential requirements and other provisions of Directive
2014/53/EU. For the complete CE DoC, please access the website
below to get more information:
https://businessportal2.alcatel-lucent.com/
Waste Electrical and Electronic Equipment (WEEE) Statement
ALE products are subject to separate
collection and treatment in the EU Member
States, Norway, and Switzerland when they
are at end of life, and therefore are marked
with the symbol shown. The treatment
applied to these products in these countries
shall be compliant with the applicable
national laws which are under the
implementing of Directive 2012/19/EU on Waste of Electrical and
Electronic Equipment (WEEE).
European Union RoHS
ALE products are compliant with the EU Restriction of Hazardous
Substances Directive 2011/65/EU (RoHS). EU RoHS restricts the
use of specific hazardous materials in the manufacture of
electrical and electronic equipment. The restricted materials
under the Directive are Lead (including Solder used in printed
circuit assemblies), Cadmium, Mercury, equivalent Chromium,
and Bromine.
[REMAINING SECTIONS INTENTIONALLY LEFT BLANK]