ASSEMBLY INSTRUCTIONS Description : 5 DRAWER CHEST RTA Printed in Vietnam -1-
BEFORE ASSEMBLY Thank you for purchasing this quality product. This product has been designed for easy assembly and constructed for durability. All parts were checked prior to packaging to insure quality. Prior to beginning assembly, however, make sure all parts and hardware are included and free of obvious defect. If a part is missing or defective, please contact the store where purchased.
PART LIST When unpacking, please be careful not to discard any parts with the packaging.
HARDWARE LIST When unpacking, please be careful not to discard any parts with the packaging. Before continuing, please make sure you have all of the following hardware: NO Description Qty 1 Allen key (M4x80mm) 3 5 NO Description Qty 1 2 Bolt (M6 X 30mm) 12 Spring washer (6.5x11mm) 12 4 Flat Washer (6.
STEP 1 Attach top (A), center panel (D), and bottom panel (C) to a side panel (B) with bolts (2) and washers (3) and (4) .Tighten with Allen key (1). Slide back panel (F), and back rail (E) into the groove as shown below. STEP 2 Attach bottom panel (C), center panel (D), and top (A) to the other side panel (B) with bolts (2), and washers (3) and (4) .Tighten with Allen key (1).
STEP 3 Attach back rail (E) to side panels (B) with screws (5) .Tighten with a screwdriver. Attach the steel band (9) to Chest with screws (11) as shown below. STEP 4 Attach drawer sides (H) to drawer front (G) with screws (5). Tighten with a screwdriver Insert drawer bottom (J) into the grooves at bottom of drawer sides (H), and drawer front (G) as shown below.
STEP 5 Attach drawer back (I) to drawer sides (H) with screws (5) as shown below. Tighten with a screwdriver. STEP 6 Attach support bars (K) to bottom of drawers with screws (8) as shown below. Tighten with the screwdriver.
STEP 7 Attach knobs (7) to front of drawers with screws (6). Tighten with the screwdriver. Stick the warning labels (10) inside the drawers before use STEP 8 Attach the steel band (9) to the wall with screws (5) as shown below (to secure the product and prevent tipping).
