Installation and Safety Instructions

Carefully remove the fixture from the carton and check that all parts
are included, as shown in Figure 1. Be careful not to misplace any of
the screws or parts which are needed to install this fixture.
FIGURE 1
*NOT INCLUDED
BEFORE YOU BEGIN
Installation And Safety Instructions
Line art shown may not exactly match the fixture enclosed. However, the installation instructions do apply to
this fixture. Fill in Item Number on Carton and File This Sheet For Future Reference. ITEM#_______________
• Be sure the electricity to the system you are working on is turned
off; either the fuse removed or the circuit breaker set at off.
• Use of other manufacturers components will void warranty, listing
and create a potential safety hazard.
• If you are unclear as to how to proceed, contact a qualified
electrician.
• You don’t need special tools to install this fixture.
•
Be sure to follow the steps in the order given.
• Under no circumstances should a fixture be hung on house
electrical wires, nor should a swag type fixture be installed on a
ceiling which contains a radiant type heating system.
• Read instructions carefully.
• Save these instructions.
IMPORTANT SAFETY INSTRUCTIONS
*
OUTLET BOX
*OUTLET BOX
SCREWS
*WIRE
CONNECTORS
SCREW
COLLAR (E)
CANOPY (G)
MOUNTING
BAR (A)
*GROUND
WIRE
CHAIN (I)
NUT (B)
SCREW
COLLAR
RING (F)
FIXTURE LOOP (H)
GREEN
GROUNDING
SCREW (D)
NIPPLE (C)
Attach fixture loop (H) to top of fixture (if applicable).
STEP 1:
IMPORTANT: DO NOT ATTACH FIXTURE DIRECTLY TO OUTLET BOX.
Secure mounting bar (A) to outlet box with outlet box scr
ews (not
supplied). Thr
ead nut (B) on nipple (C) so that 3 threads are exposed
above nut (B). Thread nipple (C) into mounting bar (A) and secure
with nut (B). Attach screw collar (E) to nipple (C).
STEP 2:
Using 2 pairs of pliers, open one link of chain (I) and connect it to the
fixture loop (H) at the top of the fixture. (If applicable).
STEP 3:
Slide the scr
ew collar ring (F) and canopy (G), in that or
der, over
chain (I). Open one link on the other end of the chain (I) and attach it
to the screw collar (E) which has been mounted to the ceiling nipple
(C).
BE SURE TO CLOSE ALL CHAIN LINKS COMPLETEL
Y
.
STEP 4:
INST
ALLATION
To clean, wipe fixture with a soft cloth. Clean glass with a mild soap.
Do not use abrasive materials such as scouring pads or powders,
steel wool or abrasive paper.
Keep this sheet for future reference, and in case you need to order
replacement parts. Parts for this fixture can be ordered from place
of purchase. Be sure to use exact wording from illustration when
ordering parts.
CLEANING
ORDERING PARTS
GROUND
WIRE (M)
GLASS
PANELS (L)
CAGE (J)
RETAINING
SCREWS
(K)