User's Manual

User Manual
RS2929B
CD Music System
It’s important to read this User Manual prior to using your new
product for the rst time.
FCC Information
This device complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined
by turning the equipment o and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
• Reorientorrelocatethereceivingantenna.
• Increasetheseparationbetweentheequipmentandreceiver.
• Connecttheequipmentintoanoutletonacircuitdierentfromthattowhichthereceiver
is connected.
• Consultthedealeroranexperiencedradio/TVtechnicianforhelp.
WARNING:Changesormodicationsnotexpresslyapprovedbythepartyresponsiblefor
compliance could void the user’s authority to operate the equipment.
For Customers in Canada
This apparatus complies with the Class B limits for radio noise emission set out in radio
interference regulations.
CANICES-3(B)/NMB-3(B)
Warning:
• TheACadapterisusedasdisconnectdeviceanditshouldremainreadilyoperableduring
intended used. In order to disconnect the unit from the mains completely, the AC adapter
should be disconnected from the mains socket outlet completely.
• The AC adapter of unit should not be obstructed OR should be easily accessed during
intended use.
• Minimum10cm(4inches)distancesaroundtheunitforsucientventilations.
• Theventilationshouldnotbeimpededbycoveringtheventilationopeningswithitems
such as newspaper, table-cloths, curtains, etc.
• Nonakedamesourcessuchaslightedcandlesshouldbeplacedontheunit.
On Safety
• Shouldanyobjectsorliquidsfallintotheunit,disconnectthepowersupplyandhavethe
unit checked by qualied personnel before any further operation.
• Theunitshallnotbeexposedtodrippingorsplashingandthatnoobjectslledwithliquid,
such as vases, shall be placed on the unit.
SAFETY PRECAUTIONS LOCATION OF CONTROLS
REMOTE CONTROL SYSTEM CONNECTIONS LINE IN CONNECTION
CHARGE YOUR SMARTPHONE/TABLET
CLOCK SETTING
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Followallinstructions.
5. Do not use this apparatus near water.
6. Clean only with dry cloth.
7. Do not block any ventilation openings. Install in accordance with the manufacturer’s
instructions.
8. Do not install near any heat sources such as radiators, heat registers, stoves, or other
apparatus (including ampliers) that produce heat.
9. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug
has two blades with one wider than the other. A grounding type plug has two blades and
a third grounding prong. The wide blade or the third prong are provided for your safety.
If the provided plug does not t into your outlet, consult an electrician for replacement
of the obsolete outlet.
10. Protectthepowerplugfrombeingwalkedonorpinchedparticularlyatplugs,convenience
receptacles,andthepointwheretheyexitfromtheapparatus.
11. Onlyuseattachments/accessoriesspeciedbythemanufacturer.
12. Use only with a cart, stand, tripod, bracket, or table specied by the
manufacturer, or sold with the apparatus. When a cart is used, use caution
whenmovingthecart/apparatuscombinationtoavoidinjuryfromtip-over.
13. Unplug this apparatus during lightening storms or when unused for a long
period of time.
14. Referallservicingtoqualiedservicepersonnel.Servicingisrequiredwhen
the apparatus has been damaged in any way, such as the power-supply cord
or plug is damaged, liquid has spilled or objects have fallen into the apparatus,
theapparatushasbeenexposedtorainormoisture,doesnotoperatenormally,orhas
been dropped.
IMPORTANT SAFETY INSTRUCTIONS
Portable
Cart
Warning
WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT
EXPOSE THE UNIT TO RAIN OR MOISTURE.
TO AVOID ELECTRICAL SHOCK, DO NOT OPEN THE CABINET.
REFER SERVICING TO QUALIFIED PERSONNEL ONLY.
This product contains a low
power laser device.
1. DISPLAY
2.
FUNCTION button
3.
STANDBY/ON button
4.
/ / TUNE – / + button
5.
PROG/MEM button
6. PAIR button
7. Bluetooth® indicator
8. CD Door
9. Timer indicator
10.
VOLUME button
11.
STOP button
12. Line in jack
13.
PLAY/PAUSE button
14. USB port (for charging only)
15. Remote sensor
1. STANDBY/ON button
2. SLEEP button
3. /PROG/MEM button
4. RANDOM button
5. /MEM.UP button
6. STOP button
7. PRESET EQ button
8. TIMER button
9. FUNCTION button
10. PAIR button
11. / / TUNE – / + button
12. VOLUME +/– buttons
13. PLAY/PAUSE button
USING THE REMOTE CONTROL CORRECTLY
• PointtheremotecontrolattheREMOTESENSORlocatedontheunit.
• Whenthereisastrongambientlightsource,theperformanceoftheinfraredREMOTE
SENSOR may be degraded, causing unreliable operation.
•Therecommendedeectivedistanceforremoteoperationisabout19feet(6meters).
TO CHANGE REMOTE BATTERY
1. Open the battery door.
7
8
9
10
11
12
13
1
2
3
4
5
6
2.InsertoneCR2025(3V)sizebattery.
ATTENTION
Take out the plastic sheet
before operating the remote
control.
BATTERY REPLACEMENT
When the battery becomes weak, the operating distance of the remote control is
greatly reduced and you will need to replace it.
NOTE : If the remote control is not going to be used for a long time, remove the
battery to avoid damage caused by battery leakage corrosion.
WARNING :Donotdisposeofbatteryinre;batterymayexplodeorleak.
CAUTION :Dangerofexplosionif batteryisincorrectlyreplaced.Replaceonly
with the same or equivalent type.
SPEAKER CONNECTIONS
Connect the right speaker to the R terminal and the left speaker to the L terminal.
NOTE : Connecting speakers other than the speakers supplied with the unit may
damage the unit.
Setting the clock can only be done in STANDBY mode.
• IftheunitispluggedinwiththesuppliedACadapterandtheunitisinstandby
mode.
1. Press and hold the
/PROG/MEM button until the hour
digits blink.
2. Press the / button to adjust the desired hours and
press the /PROG/MEM button once to conrm, then the
minute digits blink.
3. Press the
/ button to adjust the desired minutes
and press the /PROG/MEM button once to start clock.
12:00PM=NOONtime,and“PM”appears.
USING THE AC ADAPTER
Using an AC adapter other than the one supplied with the unit may damage the
unit.ThisACadapteroperatesonAC100-240V~50/60Hz.
CAUTIONS:
• Beforeuse,ensuretheratedvoltageoftheadaptermatchesyourlocalvoltage.
• TheincludedACadapterisforusewiththisunitonly.Donotuseitwithother
equipment.
• Ifyouarenotgoingtousetheunitforalongtime,disconnecttheACadapter
from the wall outlet.
• WhenevertheACadapterispluggedintoawalloutlet,electricityisrunning
through the unit, even when the power switch is turned o.
On Use
Never use the unit where it would be subject to:
- Heat sources such as radiators or air ducts.
- Direct sunlight.
LISTENING TO THE RADIO
1. Press the STANDBY/ON button to turn the unit on.
2. Press the FUNCTION button to switch to TUNER mode.
3. Press the / button to tune in to a station.
• Adjustthevolume.
Searching for a Station Automatically
• Press and hold the  / button until the tuner starts searching for a
station, then release. After tuning in a station, the search stops.
• Thesearchmaynotstopatastationwithaveryweaksignal.
Presetting Stations
Theunitcanstoreatotalof10stationsinmemory.Presettingallowsyoutotune
in to a station directly.
1. Tune in to a desired station.
2. Press the /PROG/MEMbutton.Thepresetnumberwillblinkandthe“MEM”
indicator will be shown on the display.
3. Press the /MEM.UP button to select the preset number.
4. PressthePROG/MEM button again to store it in memory.
5. Repeatsteps1-4tostoreotherstations.
Tuning in to a Preset Station
Press the /MEM.UP button to select a preset number.
For Better Reception
Fully unwind the antenna wire. Extend the antenna wire and place it in the
position that sounds best.
Note: Do not connect the FM antenna to an outside antenna.
Whenthereceptionisgood,the“
”iconwillappearonthedisplay.
After listening to the radio, press the
STANDBY/ON button to turn the unit o.
CONNECTING TO LINE IN FOR OTHER SOUND SOURCES
You can connect audio devices such as your CD player or MP3 player to the
unit via the LINE IN jack. To do this, connect an audio cable from the line out or
headphone out jack of the other audio device to the LINE IN jack on the rear of
unit. Press the FUNCTION button to switch to AUX mode.
Note: We recommend you unplug the device from the LINE IN jack when
not in use.
You can charge your smartphone/tablet through the USB socket with a USB
cable (not supplied).
• ConnectaUSBcable(notsupplied)totheUSBsocketonthefrontoftheunit
and the dock connector on your smartphone/tablet.
RIGHT
SPEAKER
BOX
LEFT
SPEAKER
BOX
AC
adapter
To AC
outlet