User's Manual

ManualsBrandsAlcatel USA Marketing ManualsElectronics5 GHz rack-mounted point to point transceiver

Table Of Contents

9500 MPR Product Information 57

1 — FCC part 15 subpart B

1.1 — 9500 MPR-A unlicensed radio

The JF6-9558H/6933B-9500MPT (MPT-HL) unlicensed radio provides fast deployment

of service with microwave radio. No license and small antennas (no FCC and Industry

Canada requirements) allow immediate turn-up. After the license is received, the

unlicensed MPT-HL radio can be easily converted to the lower 6 GHz licensed band.

The JF6-9558L/6933B-9558L and JF6-9558L-D/6933B-9558L-D (MPT-HLC) unlicensed

radio provides fast deployment of service with microwave radio. No license and small

antennas (no FCC and Industry Canada requirements) allow immediate turn-up. After the

license is received, the unlicensed MPT-HLC radio can be easily converted to the lower 6

GHz licensed band.

The JF6-9558HC/6933B-9558HC (9558HC) unlicensed radio provides fast deployment of

service with microwave radio. No license and small antennas (no FCC and Industry Canada

requirements) allow immediate turn-up. The 9558HC unlicensed radio can not be upgraded

to licensed operation.

The JF6-9558H/6933B-9500MPT, JF6-9558HC/6933B-9558HC, JF6-9558L/6933B-

9558L and JF6-9558L-D/6933B-9558L-D unlicensed radio operates in the 5725-5850

Information, Scientific, and Medical (ISM) band in accordance with FCC Part 15.247 and

IC RSS-210. This unlicensed radio, although operating in the same band as a spread

spectrum radio, operates using narrower bandwidths than spread spectrum.

The 9558HC 5.8 Unlicensed band (JF6-9558HC/6933B-9558HC) has been certified by the

FCC and Industry Canada as of August 7, 2012.

1.2 — FCC Class B compliance statement

The JF6-9558H/6933B-9500MPT, JF6-9558HC/6933B-9558HC, JF6-9558L/6933B-

9558L, and JF6-9558L-D/6933B-9558L-D unlicensed radio have been tested and found to

comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules

and IC RSS-210. These limits are designed to provide reasonable protection against

harmful interference when the equipment is operated in a commercial environment. This

DRAFT

Summary of content (18 pages)

PAGE 1
— FCC part 15 subpart B 1.1 — 9500 MPR-A unlicensed radio T The JF6-9558H/6933B-9500MPT (MPT-HL) unlicensed radio provides fast deployment of service with microwave radio. No license and small antennas (no FCC and Industry Canada requirements) allow immediate turn-up. After the license is received, the unlicensed MPT-HL radio can be easily converted to the lower 6 GHz licensed band.
PAGE 2
FCC Class B requirements equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. 1.3 — FCC Class B requirements This device complies with part 15 of the FCC Rules and IC RSS-210.
PAGE 3
IETF RFC 2474 • IETF RFC 2475 • IETF RFC 3550 • IETF RFC 0793 • IETF RFC 0791 • IETF RFC 1157 • IETF RFC 768 • IETF RFC 2616 • ITU-T G.664 • ITU-T G.703 • ITU-T G.704 • ITU-T G.706 • ITU-T G.775 • ITU-T G.823 • ITU-T G.8261 • ITU-T G.826 • ITU-T G.
PAGE 4
JF6-9558H and JF6-9558HC (unlicensed) radio The JF6-9558H/6933B-9500MPT and JF6-9558HC/6933B-9558HC unlicensed radio operates in the 5725-5850 Information, Scientific, and Medical (ISM) band in accordance with FCC Part 15.247 and IC RSS-210. This unlicensed radio, although operating in the same band as a spread spectrum radio, operates using narrower bandwidths than spread spectrum. The MPT-HC 5.
PAGE 5
Radio For the management of mono-directional radio links, different configurations are needed on each side of the link.
PAGE 6
Radio The JF6-9558L/6933B-9558L and JF6-9558L-D/6933B-9558L-D (MPT-HLC) unlicensed radio provides fast deployment of service with microwave radio. No license and small antennas (no FCC and Industry Canada requirements) allow immediate turn-up. After the license is received, the unlicensed MPT-HLC radio can be easily converted to the lower 6 GHz licensed band. The JF6-9558HC/6933B-9558HC (9558HC) unlicensed radio provide fast deployment of service with microwave radio.
PAGE 7
Radio • Field expandable to higher capacities. • Common network management with licensed radios. • Common spares and training with licensed radios • Adaptive Modulation - automatic interference countermeasures Disadvantages: • Interference from other 5725-5850 ISM band transmissions are possible • Operating restrictions • 5.725 to 5.850 GHz band • Performance could deteriorate due to interference as the frequency band becomes congested. Antenna Recommendations: Frequency – 5.
PAGE 8
Radio The antenna(s) used for this transmitter must be installed to provide a separation distance of at least 12 meters from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter. Caution: Danger of public exposure to long term RF radiated energy. When using a 1 ft flat panel antenna with a 1 watt (+30 dBm) output power, the antenna must be located in an area that does not allow the general population access to within 12 meters (5.8 Ghz) of the antenna.
PAGE 9
Radio B1 5760 B1’ 5825 B2 5765 B2’ 5830 B3 5770 B3’ 5835 B4 5775 B4’ 5840 B5 5780 B5’ 5845 Notes: The drawing above shows the 5 MHz channels used by the JF6-9558H/5933B9558MPT radio. Gray channels are designated “G”. Blue channels are designated “B”. Transmit and receive channels have a 65 MHz separation. 2. RF filters are centered on channels G3, B3, G3’, and B3’. 3. The flexibility of the JF6-9558H/6933B-9500MPT allows any radio to grow to 183 Mb/s without a hardware upgrade.
PAGE 10
Radio 1. The drawing above shows the 5 MHz channels used by the F6-9558L-D/6933B9558L-D radio. Gray channels are designated “G”. Blue channels are designated “B”. Transmit and receive channels have a 63 MHz separation. 2. RF filters are centered on channels G3, B3, G3’, and B3’. 3. The flexibility of the F6-9558L-D/6933B-9558L-D allows any radio to grow to 183 Mb/s without a hardware upgrade. The MPT-HLC 5.
PAGE 11
46 — UDS-129 MPT-HLC transceiver Table 46.
PAGE 12
Features and application notes Table 46.
PAGE 13
Features and application notes • High-capacity, long-haul RF transmission shelf • Supported on EASv2, P8ETH, Core-E, CorEvo, and MSS-1 SFP ports in 1+0 and 1+1 configurations, L1 and L2 Radio LAG ports • Support for the following RF configurations when connected to Core-E, CorEvo, EASv2, P8ETH and MSS-1 SFP ports: Non-Standby with Space Diversity • Hot Standby • Hot Standby with Space Diversity • Frequency Diversity • 2+0 LAG • 2+0 LAG with Space Diversity • 2x(1+0) single shelf repeater w
PAGE 14
Description 46.2 — Description The MPT-HLC Transceiver card is a microprocessor controlled RF transceiver that interfaces the Core-E card, CorEvo card, EASv2 card, P8ETH card, or MSS-1 unit MPT-HLC port with the antenna. The MPT-HLC Transceiver microprocessor manages transmit and receive frequencies, transmit power, alarming, and performance monitoring. The MPT-HLC Transceiver resides in the MPT-HL shelf. 46.
PAGE 15
Indicators, connectors, and control Table 46.2 — MPT-HLC transceiver front panel indicator details STATUS DEFINITION Status (S) Off Card not powered Green Blinking FPGA Downloading, or SW Booting. (Different blink rates identify each step of the startup process.) Green In Service, Normal Operation, and Properly Provisioned. EPS or RPS currently In-Service/Active. Yellow Card Properly Equipped and Provisioned in 1+1, currently in Standby.
PAGE 16
Functional overview Table 46.2 — MPT-HLC transceiver front panel indicator details (Continued) INDICATOR STATUS DEFINITION Link (L) Off Link Down On Link Up Off No Tx/Rx activity Blinking Tx/Rx activity Activity (A) Table 46.3 — MPT-HLC transceiver front panel connector details TYPE FUNCTION Battery Power D-SUB MPT-HLC Transceiver Power Input SFP Port SFP Communication link with the EAS card Craft Terminal/CT RJ45 Not supported in this release. AF T CONNECTOR Table 46.
PAGE 17
RSSI monitoring point 46.5 — RSSI monitoring point The RSSI is available on the maintenance LEMO connector and is used to manually align the antenna in the field. The Higher the RSSI voltage is the better the antenna is aligned. Table 46.5 — Typical RSSI voltage levels with RSL for MPT-HLC Measurements (with MPT-HLC) PRX cord (Vdc) 4.94 4.31 3.72 3.10 2.46 1.86 1.25 0.62 0.
PAGE 18
D R AF T RSSI monitoring point 1096 9500 MPR Product Information