User's Manual

T
T
h
h
e
e
W
W
r
r
i
i
s
s
t
t
T
T
r
r
a
a
n
n
s
s
m
m
i
i
t
t
t
t
e
e
r
r
(
(
W
W
T
T
R
R
M
M
)
)
L
L
o
o
n
n
g
g
b
b
a
a
t
t
t
t
e
e
r
r
y
y
l
l
i
i
f
f
e
e
W
W
a
a
t
t
e
e
r
r
p
p
r
r
o
o
o
o
f
f
e
e
d
d
z
z
A
A
c
c
t
t
i
i
v
v
e
e
B
B
u
u
t
t
t
t
o
o
n
n
z Pressing the Active Button for more than 1 sec will activate the
Main Unit, causing it to dial emergency call or alarm.
z When the Main Unit receives the alarm signal and is being
activated, you can stop the activity if desired by pressing this button
for more than 8 sec.
z Press and hold the Active Button for 15 seconds to send test code
and open supervision function. After that the WTRM will send a
supervisory code every 21~30hr automatically.
<Note>
 When the supervision function is opened, it can not be pressed and
hold for 15 sec to send test code or closed the supervision function.
 When the WTRM is in low battery condition, the WTRM change to
send supervisory code every 12 hours.
z
z
L
L
e
e
a
a
r
r
n
n
I
I
n
n
W
W
T
T
R
R
M
M
Every Wrist Transmitter has a unique numeric code called “ID code”. The ID code
enables the Main Unit to identify the signal is transmitted from the Wrist Transmitter.
At the same time, it also prevents interference from outside sources.
Press the Button on the WTRM, a radio signal will be transmitted to the control panel for
learning. Please refer to the operation manual of your control panel.
z
z
B
B
a
a
t
t
t
t
e
e
r
r
y
y
L
L
i
i
f
f
e
e
The Wrist Transmitter uses one CR2032 3V Lithium battery as its power source.
The battery can last for more than 6 years.
The WTRM can detect if the battery is low. Low battery detection operates at a threshold
of 2.2V where the WTRM has enough reserve power to typically operate for 8 month
before complete exhaustion.
If the battery voltage is less than 2.2V and transmit 3 times, at the forth transmitting a Low
Battery signal will be send to the control panel to notify the user.
This device complies with Part 15 of the FCC rules and RSS-210 of CANADA.
Operations is subject to the following two conditions:
(1)This device may not cause harmful interference, and
(2)This device must accept any interference received, including interference that may
undesired operation.