ALARM VOICE SYSTEM User Guide SBC PROTECTING THE ONES YO LOW LE FCC ID: SILICA Masters Report No.
Additions to User's Manual “Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment” “This equipment complies with Part 68 of the FCC rules and the requirements adopted by the ACTS. On the back of this equipment is a label that contains, among other information, a product identifier, US:RPIALO3BSBC.
“CAUTION: To ensure proper operation, this equipment must be installed according to the enclosed installation instructions.
Dear New Alarm Force Client, We would like to take this opportunity to personally welcome you as a new Alarm Force client. We are sure that you and your family will be pleased with the protection that the Alarm Voice system provides To thank you for choosing Alarm Force, we have enclosed 3 referral coupons. By telling your friends, family, and co-workers about Salesforce, you wilt be rewarded with $28 quench — equivalent to the cost of ane month's monitoring for every installed referral.
TWO IMPORTANT NUMBERS Personal ID# This eight digit number is assigned to you by Alarm Force. The installer wilt give you a card with your personal 10# at the time of installation. The Personal ID # is required by our computers for your identification. In the event of an alarm, you must be prepared to give this confidential number or prearranged password to the Central Monitoring Station operator to cancel the dispatch of authorities to your premises. Guard this number carefully; it cannot be changed.
Arming in AWAY MODE from a Touchstone Phone {when no one remains on the premises) 1. Lift the receiver of any touchstone phone. 2, Listen for the dial tone. 3. Enter your four digit arming/disarming code. (See page 2) 4. Press the star key twice. Ix) 5. A voice prompt will announce “Armed”, If you do not hear the prompt repeat from step one. 6. Hang up the receiver, 7.
To disarm the system in AWAY MODE and HOME MODE: 1. Enter your four digit arming/disarming code. 2. Press the key. The system will respond with the voice prompt “Disarmed” Press the auto button on the keypad to hear a voice prompt indicating the status of your system. In The Event of An Emergency Setting off an EMERGENCY alarm will establish two way voice contact with Central Station operators, No siren will sound. An emergency signal will be sent even if the system is disarmed.
For example: it your arming code is 2-34, 10 test your system press : DEODORIZE) 4. Listen for voice prompt “Test mode”. This tells you that the system is now in TEST mode and will not send an alarm signal to the Central Monitoring Station, Test mode will automatically turn off after 10 minutes or if a signal to cancel test mode is received.
After changing batteries, reactivate each sensor while still in TEST mode. You should hear a beep from the system confirming the proper operation of the sensor. If you do not hear the beep, ensure the batteries are installed correctly before calling for service. Replacing Back-up Battery Step 1: Disarm your system (pg. 8). Turn off back-up battery switch located on the back of the control unit (pg. 14), Unplug the power adapter from the power outlet.
“Line OK” This message is heard upon power up to self test the unit or when lost telephone line service is restored. PROGRAMMABLE FEATURES Entry Door Chime The entry chime can be turned on and off. 1. Lift the receiver of your touchstone phone. 2. Press the star key, then the number 2 key, then again the number 2 key, then hold down the star key until you hear one beep. You will hear the voice prompt “chime off 3. Your chime is now disabled. 4. To reverse this process repeat steps one and two.
Calling For Service When your MYOCARDIAL system is installed you wilt receive your Personal ID# card which will advise you of the telephone number to call should You require service. If your card has been lost or misplaced, please call Alarm Force Head Office from 8 am, to lip, EST Monday to Friday at 1-866-267-2055 for the telephone number of your local service representative. An appointment with a technician will be scheduled as $001 as possible.
KEEP IN A SAFE PLACE HELP US PREVENT FALSE ALARMS. Alarm Certificate TEST YOUR SYSTEM REGULARLY. An alarm system is operational at the following 13 SERVICEABILITY_ = location and is being centrally monitored : | MONITORING STATION 1 877 267 2001 24 hours a day. i Central Station ULC Certificate number: S301 NY . KEEP IN A SAFE PLACE 1* A -3lo HHH Date of installation sl SN HELP US PREVENT FALSE ALARMS. TEST YOUR SYSTEM REGULARLY. Client Name -. FOR SERVICE CALL...