Installation Manual

www.alarm.com • 1-877-389-4033

Smart Thermostat

ADC-T2000

Quick

Installation

Guide

Alarm.com Logo are registered trademarks of Alarm.com.

www.alarm.com • 1-877-389-4033

Pull up your customer’s account

and select the emPower® button.

Click on Z-Wave Devices and

select the Smart Thermostat.

Review and update Installer

settings to configure.

Configure Your Thermostat

Using MobileTech

Use MobileTech to quickly configure your

new Smart Thermostat.

Download MobileTech today!

www.alarm.com/mobiletech

Congure your system

You must program the thermostat settings

(or run through the online setup wizard)

before putting the thermostat into heating or

cooling mode.

Visit the Alarm.com Dealer Website or use

MobileTech to congure the system parameters.

Dealer Website > Customers > Equipment >

emPower Devices > Congure Device

For more detailed instructions, please visit:

Dealer Website > Support & Sales >

Support Documentation

For questions, please contact

Support@alarm.com.

Connect the Thermostat

to the system

Now you can connect the Alarm.com Smart

Thermostat to the Alarm.com home system

using the Z-Wave network.

To pair, make sure the thermostat is in

OFF mode (no mode icons are lit) and press

and hold the DOWN  ) button until you

see the RADIO ( ) icon.

PAGE 1
1 Connect the Thermostat to the system Configure Your Thermostat Using MobileTech Now you can connect the Alarm.com Smart Thermostat to the Alarm.com home system using the Z-Wave network. Use MobileTech to quickly configure your new Smart Thermostat. To pair, make sure the thermostat is in OFF mode (no mode icons are lit) and press and hold the DOWN ( ) button until you see the RADIO ( ) icon. 1 Pull up your customer’s account and select the emPower® button.
PAGE 2
1 Test the system 5 Verify that the heating and/or cooling system is operating properly with the existing thermostat. 6 9 Attach the Alarm.com Smart Thermostat Install the new back plate If necessary, first install the optional trim plate to cover any holes or marks left from the old thermostat. 7 3 Install the batteries TIP: Check that all wires are a proper gauge (18-24 AWG), have approximately 1/8” exposed straight ends, and are in good condition.