User's Manual

Rhein Tech Laboratories, Inc. Client: Alarm.com

360 Herndon Parkway Model: ADC-UB-100-AT

Suite 1400 Standards: FCC 15.247/IC RSS-247

Herndon, VA 20170 ID’s: YL6-143UB100AT/9111A-143UB100AT

http://www.rheintech.com Report #: 2015182

Page 41 of 55

Appendix K: Manual

Please refer to the following pages.

PAGE 1
Rhein Tech Laboratories, Inc. 360 Herndon Parkway Suite 1400 Herndon, VA 20170 http://www.rheintech.com Appendix K: Client: Alarm.com Model: ADC-UB-100-AT Standards: FCC 15.247/IC RSS-247 ID’s: YL6-143UB100AT/9111A-143UB100AT Report #: 2015182 Manual Please refer to the following pages.
PAGE 2
User Guide Alarm.com Multisensor Summary The Alarm.com Multisensor is a multi-purpose sensing solution for the connected home, designed to work with a broadband or cellular automation hub. The Multisensor can detect door/window status, PIR motion, and accelerometer activity. Additionally, a push button can be configured to allow the user to manually trigger automation rules for other Z-Wave devices connected to the Hub.
PAGE 3
configurations. To perform a network reset, push and hold the Reset Button on the back of the Multisensor until the Ring LEDs begin flashing (approximately seven seconds), then release the button. The Status LED should begin quickly flashing red. Note that this procedure will not remove the Multisensor from the Hub. The Multisensor must be removed from the Hub using the web portal or by factory resetting the Hub.