Rhein Tech Laboratories, Inc. 360 Herndon Parkway Suite 1400 Herndon, VA 20170 http://www.rheintech.com Appendix J: Client: Alarm.com Model/HVIN: ADC-470L Standards: FCC 15.247/IC RSS-247 ID’s: YL6-143470L/9111A-143470L Report #: 2016204DTS Manual Please refer to the following pages.
Simon XT/XTi/XTi-5 LTE/IP Module | Installation Guide Simon XT/XTi/XTi-5 LTE/IP Module INSTALLATION GUIDE Introduction The LTE/IP module for Simon XT, XTi, and XTi-5 enables wireless reporting of all alarms and other system events from the Interlogix Simon XT, XTi, and XTi-5 control panel on the 4G LTE wireless (cellular) network and broadband connection (if available).
Simon XT/XTi/XTi-5 LTE/IP Module | Installation Guide Top of Panel Plastic Corner Tabs 1) Disconnect the battery leads and unplug the panel power transformer from AC power. 2) Verify that the module is inserted securely and that the antenna is snapped-in completely. 3) Connect battery leads to the battery. On the XT, make sure to observe polarity (red to + and black to –) and to keep the wires outside of the tab holding them in place. 4) Plug the panel power transformer into the AC outlet.
Simon XT/XTi/XTi-5 LTE/IP Module | Installation Guide Smoke Supervision: The Smoke Supervision setting (enables 200s smoke alarm supervision between panel and smoke detectors) for XT version 1.6 and up, XTi version 1.7 and up, and XTi-5 is not compatible with the Alarm.com LTE/IP module. This setting will be automatically disabled when the module connects and should not be enabled at the panel. The default supervision with the Smoke Supervision setting disabled is 1 hour.
Simon XT/XTi/XTi-5 LTE/IP Module | Installation Guide --- Number of Z-Wave Devices2 The total number of Z-Wave devices currently known to the LTE module. - Interactive Services Scroll up to Interactive Services and press OK --- Add Z-Wave Device2 Press OK to enter Z-Wave Add Mode. Make sure the device you are trying to add is powered up and within 3 to 6 feet of the Simon XT, XTi, or XTi-5 panel. Refer to the manufacturer’s instructions for button presses required to enroll device.
Simon XT/XTi/XTi-5 LTE/IP Module | Installation Guide ---- Update 2WTTS ---- Remove From 2WTTS ---- Last Temp. Read -- Request Weather Update Press OK to force an update of the thermostat information shown on the touch screen (2WTTS). Note that these updates may take several minutes to complete. To speed up the process, go into System Programming. This puts the panel in high-speed communication mode with the touch screen.
Simon XT/XTi/XTi-5 LTE/IP Module | Installation Guide ---Create Account This menu is available only to installers who have their own Alarm.com account creation system. You must enter a Technician ID and a Lead ID in order to use this menu. System Programming + Master Code Scroll to Programming and enter the Master Code. - Interactive Services Select Interactive Services. -- Module Status Provides status and troubleshooting information for the LTE/IP module.
Simon XT/XTi/XTi-5 LTE/IP Module | Installation Guide Walking the Customer through New User Setup on the Web This section describes how to help your customer set up their website account, and only applies to customers on an interactive service plan with an online account. (Skip this step for customers using the module for wireless signaling only). This equipment complies with the FCC RF radiation exposure limits set forth for an uncontrolled environment.