User's Manual
Warning
1. SOS key: Dedicated bu on for any emergency situa ons, it can be configured as Emergency call
feature to call out pre-configured 3 numbers in a loop.
To configure SO S key:
Press and hold SOS key for several seconds to configure the numbers.
Go to phone webpage→Phone→Emergency Call→Emergency Call.
: To help users contact with their important rela
ves easily and quickly,three dis nct 2. Memory Key
bu ons can be configured to save phone number. When there is a need,simply press the bu on to
reach their families.
To configure Memory keys:
Press and hold Memory key for several seconds to configure the number.
Go to phone webpage→Phone→Key/Display→Func
on key.
3. RF key: The RF key is the small size of pendant on your hand, which enabled mul ple features gives
user remote control ability to control the phone.
To configure RF key:
Go to phone webpage→Phone→Emergency Call→RF key.
2016
2. Launch web browser and type in the I P address to access web interface. Login with username and
passwords(admin by default).
1. A
er se ng up the network and power, connect IP phone to your computer, then press menu
so
key then select Status then check the IP address in the main menu. ( If you are using DHCP to
obtain IP address )
3
. Register the device using your SIP account.( Please refer to user manual for more informa on)
Pick up the handset, enter a phone number then press the so
key or # key to make a call.
Press RF key to ini
ate a call in the phone.
Press the Redial key , select a dialed number then press the Redial key again.
.
M1
M2
M3
YS15000003
Any Changes or modifica ons not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
This device complies with part 15 of the FC C Rules. Opera
on is subject to the following two condi ons:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired opera
on.
This equipment complies with F CC radia
on exposure limits set forth for an uncontrolled environment .
This transmi
er must not be co-located or opera ng in conjunc on with any other antenna or transmi er.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FC C Rules. These limits are designed to provide reasonable protec
on against harmful interference
in a residen
al installa on. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instruc
ons, may cause harmful interference to radio communica ons.
However, there is no guarantee that interference will not occur in a par
cular installa on. If this equipment does
cause harmful interference to radio or television recep
on, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separa
on between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/T V technician for help.
FC C Cau on