Model:BPT14-24AL-11 Bathroom Ventilation Fan with Light Questions, problems, missing parts? Before returning to the store, call AKICON Customer Service 8 a.m.-6 p.m.,EST, Monday-Friday 1-302-213-4406 1-302-526-0542 AKICONSHOP.
Page 1 Model: BPT14-24AL-11 Table of Contents GENERAL SAFETY INFORMATION AND WARNINGS .............................................................................................................................. 1 LIST OF INCLUDED PARTS AND ACCESSORIES ....................................................................................................................................... 2 LIST OF ADDITIONAL TOOLS/SUPPLIES REQUIRED FOR INSTALLATION ..........................................................
Model: BPT14-24AL-11 Page 2 LIST OF INCLUDED PARTS AND ACCESSORIES NOTE: Unpack and carefully remove unit from carton. Refer to the supplies and parts list to verify that all parts are present.
Page 3 Model: BPT14-24AL-11 LIST OF ADDITIONAL TOOLS/SUPPLIES REQUIRED FOR INSTALLATION þ Safety glasses þ 4-in. round duct, elbows if needed, installation tools and other supplies including foil duct tape or 4-in.
Model: BPT14-24AL-11 Page 4 SPECIFICATIONS Model No. Air CFM V Hz Duct Diameter Noise (Sones) BPT14-24AL-11 110 CFM 120 60 4 in. (10 cm) 1.5 DIMENSIONS Ceiling Opening – D 8 in. (20.3 cm) Ceiling Opening – W x L 9 ¼ in. x 9 ¼ in. (23.5 cm x 23.5 cm) Housing Dimension – W x L 9 in. x 9 in. (23 cm x 23 cm) Housing Dimension - D 7 11/16 in. (19.
Page 5 Model: BPT14-24AL-11 FAN HOUSING INSTALLATION (DIRECT JOIST MOUNTING OR SUSPENSION BRACKET JOIST MOUNTING) § Check the area above installation location to be sure that: a. Ductwork can be run and there is sufficient area for proper ventilation; b. Wiring can be run to the planned location (wires from the power supply to the unit should not be smaller than size 14 AWG); c. There will be access to ductwork and wiring for inspection and future maintenance; and d.
Model: BPT14-24AL-11 Page 6 Steps 3-9 All Installations: Step 3: To secure brackets to fan housing, insert Step 4: Install a 4-in. circular duct and secure to machine screws (Part #5). Tighten machine screws to housing with foil duct tape or clamp. prevent housing vibration while fan is in operation. Step 5: Disconnect the power supply before proceeding with Step 5. Run 120V 60Hz house wiring (with ground) from wall switches to fan location.
Page 7 Model: BPT14-24AL-11 Step 8: Use hardware (Part #8) to secure grille to the Step 9: Attach shade (Part #3) using decorative fan housing, (a) place washer over center hole on plate and nut (Part #8). grille, (b) add lock nut, and (c) insert the long bolt and tighten. Attach lightbulbs (Part #9 and Part #10). CLEANING THE VENTILATION FAN Cleaning the unit periodically is advisable since dust, molds, grease, and other dirt particles can affect the conductivity of the air in the unit.