User Guide

Table Of Contents

BR062518 1

Tripod Lite Series

Ultra-Light Tripod Projection Screen

USER’S GUIDE

Thank you for choosing the Tripod Lite portable projection screen! Please read this user guide before utilizing the

screen. Correct usage and maintenance will ensure a long product life.

Care & Use Instructions

◆ Dust, dirt and scratches on the projection surface will affect the picture quality, please take note of the points

below to prevent that from occurring:

1. Do not touch the projection surface with your hands

2. Do not write or draw on the projection surface

3. Do not use fingers or sharp objects to point on the projection surface; this will damage the screen material.

4. Use a soft-damp cloth to clean the projection surface; do not use chemical cleaning agents or alcohol.

5. Use clean water when dampening the cleaning cloth and do not rub against the material to clean it.

◆After using the screen, disassemble it and store it in the carrying bag provided.

◆To avoid damage and injury, the screen should only be operated by adults.

Vertical Extension Bar

Tripod Support Legs

Top Locking Wing

Middle Locking Wing

Tripod Junction

Screen Material

Support Hooks

Top Support Bar

Center Spike

Bottom Locking wing

Hanging Loops

Bottom Support Bar

PAGE 1
Tripod Lite Series Ultra-Light Tripod Projection Screen USER’S GUIDE Thank you for choosing the Tripod Lite portable projection screen! Please read this user guide before utilizing the screen. Correct usage and maintenance will ensure a long product life.
PAGE 2
What’s included? Screen Material (rolled) Tripod Stand Carrying bag Setting up the Tripod Lite Projection Screen A. Tripod Stand set up 1. Place the tripod stand in an upright position with the legs slightly above the ground. 2. Turn the bottom locking-wing counter-clockwise to extend the tripod legs and set it on the floor. Turn the locking-wing clockwise to lock the position. 3. Pull out the screen support hooks unit they are fully extended.
PAGE 3
C. Outdoor Use The center upright support is tipped with a spike- shaped Drive spike into feet ground. permit ground cap. In addition, all three tripod support the use of stakes to ground the legs to any soft soil, lawn, etc., for added stability and mild wind conditions. 1.Center Spike 2.Tripod feet Drive a stake (not included) thru the feet Tripod Screen Material Disassembly 1. Slowly roll-up the screen material until it is fully rolled as shown below.