User's Manual

Category:
External
Product/Project:
INSTALLATION
Page:
4 (12)
Subject:
INSTALLATION MANUAL SESAM 6099 TRANSMITTER
Document ID:
939045-000
Date:
2008-01-18
Written by:
Henrik Ring
Checked by:
Anders Modig
Approved by:
Henrik Ring
Version:
A1
ÅKERSTRÖMS BJÖRBO AB, SE-780 45 BJÖRBO, Sweden
Phone [phone], Fax [phone]
Vat No SE556153982501 Registrated office BJÖRBO
www.akerstroms.se
1. Intended Readers
This installation manual must be used when installing Åkerströms Sesam 6000 industrial remote
control system to ensure a secure and safe operation. The installation must be carried out by a
qualified electrician.
2. Introduction
This manual only covers the installation of the Sesam 6000 radio remote control system.
The Sesam 6000 does not implement a complete remote-control system: it provides only the set of
outputs that are driven accordingly to the actions performed by the operator on the buttons of the
transmitter.
The way the set of outputs is used for controlling the object (for instance for driving the movements
and the brakes of a machine or controlling other machine assemblies) depends on the specific
installation and is out of the scope of the Sesam 6000.
It has to be explicitly noted that received information from the controlled object is not processed by
the Sesam 6000 receiver; it is only used for information purpose. That is the Sesam 6000 has no
visibility of the controlled object.
For all the reasons exposed above, the safety of the Sesam 6000 involves mainly the states of its
output relays regardless the object’s assemblies that are driven by the relays themselves, provided
that Sesam 6000 has to be suitable for being used as a part of a radio remote-control system; other
safety aspects are related to those specific functionalities that are implemented by the Sesam 6000
itself regardless the controlled object (for instance, the handling of radio signal interruption).
The interface between the Sesam 6000 and the controlled object is intended for being implemented
by means of a specific interface assembly; this assembly is not part of the Sesam 6000 system and
for this reason is not considered in this installation manual.
The approvals that the Sesam 6000 system has are only valid for the Sesam 6000 system itself.
The complete remote-control system, where the controlled object is one part, has to be tested and
approved according to the standards/norms that are applicable and is not a part of Åkerströms
Björbo’s responsibility
Any changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.