Variant 1 DRIVING INSTRUCTION REMOTUS MC8318 923477-000 USA MANUAL MC8318 No. 923477-000 USA Page. 1 (12) Version: A0 Approved by: HH MANUAL MC8318 No. 923477-000 USA Page.
Variant 2 TRANSMITTER ON Pull out the STOP button and the transmitter will make a self-test during 0,5 seconds. The operation indicator lamp (acc.) starts blinking and the transmitter is on. MAIN CONTACTOR ON Then the transmitter is on press the signal button and this actuates the Main Contactor in the receiver (the Main Contactor of the traverse closes) and the traverse is ready for operation.
MICRO RUN (NOT SIMULTANEOUS) SIGNAL X Set the selector for MICRO / NORMAL / EXTRA in position MICRO. The micro-run movements are only at lowest speed in micro-run mode irrespective of the deflections of the manipulator. The other functions are working just as in ordinary runs. The manipulated movements are looped so that only one movement can be operated at a time. A signal can be emitted at any time during the run and is obtained as long as the push button switch is depressed.
TRANSMITTER OFF MAIN CONTACTOR OFF Depress the STOP button which switches off the transmitter. At the same time the Main Contactor is deactivated (the Main Contactor of the traverse cuts out). The operation indicator lamp goes out. TRANSMITTER LED INDICATIONS RUN DOWN ACCUMULATOR The transmitter is equipped with an indicator lamp (green and yellow) for accumulator status. The lamp blinks green when the accumulator voltage is normal(?7,2V), but starts to blink yellow when it falls (<6,9V).
CHARGING INSTRUCTIONS ∗ ∗ ∗ ∗ ∗ ∗ ∗ INSTRUCTIONS FOR CRANE OPERATORS These instructions have to be followed. Marked ! The accumulator has got power for 10 hours continuous operation. Charging time 2 hours (quick-charge) there upon automatically changes to maintenance charging which does not need supervising. The charging device has LED indication for quick charge (fixed red LED) or maintenance charge (flashing red LED). 1.
9. ! If you loose control of the crane movements, release the manipulators to obtain the zero position in order to stop the crane. If still it does not stop, actuate the STOP function. 10. ! Find out where the crane's main power disconnector is, in order to be able to quickly switch off the power if required. 11. ! Never hand over the transmitter to anybody who has not undergone training in radio-control crane operation. 12. ! After completed operation you should always switch the transmitter off with STOP.