Variant 1. DRIVING INSTRUCTION REMOTUS BC8518 928754-000 USA MANUAL BC8518 No. 928754-000 USA Version: A0 Approved by: HH Page 1 (12) MANUAL BC8518 No.
Variant 2. TRANSMITTER ON Pull out the stop button and the transmitter is switched on. The operation indicator lamp (ACC.) starts blinking and the transmitter is on. ELECTRONIC LOCK If the operating indication LED is red, the electronic lock is activated. Contact the works manager or see the Installations manual. MAIN CONTACTOR ON Then the transmitter is on, press the signal button and this actuates the Main Contactor in the receiver, and it is ready for operation.
MICRO RUN SIGNAL Push in the button for MICRO and the diode lamp for micro lights. The micro-run movements are only at lowest speed in micro-run mode irrespective of the compression of the pushbuttons. The buttons are looped so that only one movement can be operated at a time. The other functions are working as in ordinary runs. A signal can be emitted at any time during the run and is obtained as long as the push button switch is depressed. EMERGENCY STOP Depress the STOP button for Emergency STOP.
TRANSMITTER LED INDICATIONS CHARGING INSTRUCTIONS If the transmitter under start up or under operating detect a fault in any self-tests it will indicate with a continuously red light. After that the transmitter closes down. If it indicates continuously yellow light when you start up the transmitter, at least one of the pushbuttons is activated. • The battery has got power for 12 hours continuous operation. • Charging time is 2 hours.
• A WELL MAINTAINED BATTERY IS NECESSARY FOR FAULTLESS OPERATION • CHARGE THE BATTERY AS SOON AS THERE IS POSSIBILITY. 1. THE BATTERY MUST NOT BE CHARGED IF THE TEMPERATURE IS LOWER THAN +10°C OR HIGHER THAN +35°C. 2. ! Check that no unauthorized person is on or at the crane when you start to drive it. The blocking device at entry of the crane should be closed. 3. ! Check the position of the symbols for driving direction (crane-trolley travel). 4.
9. ! If you loose control of the crane movements, release the pushbuttons in order to stop the crane. If still it does not stop, actuate the STOP function. 10. ! Find out where the crane's main power disconnection is in order to be able to quickly switch off if required. 11. ! Never hand over the transmitter to anybody who has not undergone training in radio-control crane operation. 12. ! After completed operation you should always switch the transmitter off with STOP.