User's Manual

ManualsBrandsAkerstroms Bjorbo ManualsElectronicsUHF-Handheld Transmitter

DRIVING INSTRUCTION

REMOTUS BC7400 USA

Variant 1 (variant 2, see page 4)

MANUAL BC7400 No. 926137-000 USA

Version: A0 Approved by: HH

Page 1 (11)

TRANSMITTER ON

Pull out the stop button and the transmitter is switched on. The

operation indicator lamp (STATUS) starts blinking and the

transmitter is on.

MAIN CONTACTOR ON

Then the transmitter is on press the • . This activates the

Main Contactor in the receiver (the Main Contactor of the telpher)

and the telpher is ready for operation.

NORMAL RUN

The transmitter is designed with two pushbuttons for UP/DOWN

and two for FORWARD/BACKWARD. Each button is divided into

2 steps (a perceptible resistance), which facilitates the running at a

certain speed. The first speed is obtained when the pushbutton is

half compressed and the second speed is obtained when the

pushbutton is totally compressed.

All the motions can be run simultaneously and the motions stop

when the pushbutton is released, otherwise make an QUICK STOP.

MANUAL BC7400 No. 926137-000 USA

Version: A0 Approved by: HH

Page 2 (11)

Summary of content (6 pages)

PAGE 1
TRANSMITTER ON DRIVING INSTRUCTION REMOTUS BC7400 USA Pull out the stop button and the transmitter is switched on. The operation indicator lamp (STATUS) starts blinking and the transmitter is on. Variant 1 (variant 2, see page 4) MAIN CONTACTOR ON Then the transmitter is on press the • . This activates the Main Contactor in the receiver (the Main Contactor of the telpher) and the telpher is ready for operation.
PAGE 2
MICRO RUN Variant 2 Push in the button for MICRO and the diode lamp for micro lights. The micro-run movements are only at lowest speed in micro-run mode irrespective of the compression of the pushbuttons. The buttons are looped so that only one movement can be operated at a time. The other functions are work as in ordinary runs. PUSHBUTTON 1 AND 2 The diode lamps indicate which function that has been chosen.
PAGE 3
TRANSMITTER ON QUICK STOP Pull out the stop button and the transmitter is switched on. The operation indicator lamp (STATUS) starts blinking and the transmitter is on. Depress the STOP button for QUICK STOP. AUTOMATIC SWITCH OFF FUNCTION MAIN CONTACTOR ON Then the transmitter is on press •, button 7. This activates the Main Contactor in the receiver and it is ready for operation.
PAGE 4
RUN DOWN BATTERY DISCHARGED BATTERY. The transmitter is equipped with an indicator lamp for battery status (STATUS). The lamp blinks slowly when the battery voltage is normal, but starts to blink rapidly when it falls. When the indicator lamp has started blinking rapidly the transmitter can be operated for approx. 10 min. before the voltage is so low that the transmitter switches off automatically.
PAGE 5
INSTRUCTIONS FOR CRANE OPERATORS These instructions have to be followed. Marked ! 1. ! Check that the radio transmitter operates on the crane, which you are going to drive (ex. give a signal). Check the function of the radio transmitter. 2. ! Check that no unauthorized person is on or at the crane when you start to drive it. The blocking device at entry of the crane should be closed. 3. ! Check the position of the symbols for driving direction (crane-trolley travel). 4.
PAGE 6
FCC Identifier OG4BC7418 This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user´s authority to operate tne equipment. MANUAL BC7400 No.