DRIVING INSTRUCTION REMOTUS BC7400 MANUAL BC7400 No. 926137-000 Version: A0 Approved by: TB Page 1 (8) MANUAL BC7400 No.
TRANSMITTER ON MICRO RUN Pull out the stop button and the transmitter is switched on. The operation indicator lamp (STATUS) starts blinking and the transmitter is on. Push in the button for MICRO and the diode lamp for micro lights. The micro-run movements are only at lowest speed in micro-run mode irrespective of the compression of the pushbuttons. The buttons are looped so that only one movement can be operated at a time. The other functions are work as in ordinary runs.
AUTOMATIC SWITCH OFF FUNCTION CHARGING INSTRUCTIONS The transmitter is equipped with automatic switch-off function, switching off the transmitter after 2, 5, or 15 minutes after the latest use depending on what period of time has been looped. It is also possible to loop for continuous drive. The indicator lamp for operation goes out and the Main Contactor is de-energized. For renewed activation of the Main contactor restart is required, press the stop button, pull it out again and press the •.
INSTRUCTIONS FOR CRANE OPERATORS These instructions have to be followed. Marked ! 1. ! Check that the radiotransmitter operates on the crane which you are going to drive (ex. give a signal). Check the function of the radiotransmitter. 2. ! Check that no unauthorized person is on or at the crane when you start to drive it. The blocking device at entry of the crane should be closed. 3. ! Check the position of the symbols for driving direction (crane-trolley travel).