User's Manual

Model name:
Ajax MotionProtect
Outdoor (9NA)
Quick Start Guide
Before using the device, we strongly
recommend reviewing the User Manual
on the website.
Product name: Outdoor motion detector
MotionProtect Outdoor is a wireless detector to recognize
motion at a distance of up to 15 meters. MotionProtect Outdoor
is protected from masking, dust, and splashes and features pet
immunity.
Complete Set: 1. MotionProtect Outdoor; 2. SmartBracket mounting
panel; 3. CR123A battery — 2 pcs. (pre-installed); 4. Installation kit;
5. Quick Start Guide
FCC Regulatory Compliance
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Changes or
modications not expressly approved by the party responsible for com-
pliance could void the user’s authority to operate the equipment.
To maintain compliance with FCC’s RF Exposure guidelines, This equip-
ment should be installed and operated with minimum distance between
20cm the radiator your body: Use only the supplied antenna.
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful in-
terference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference
will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more
of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
ISED Regulatory Compliance
This device contains licence-exempt transmitter(s)/receiver(s)
that comply with Innovation, Science and Economic Develop-
ment Canada’s licence-exempt RSS(s). Operation is subject to
the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interfer-
ence that may cause undesired operation of the device.
(3) To maintain compliance with ISED’s RF Exposure guidelines,
This equipment should be installed and operated with minimum
distance between 20cm the radiator your body: Use only the
supplied antenna.
Lémetteur/récepteur exempt de licence contenu dans le
présent appareil est conforme aux CNR d’Innovation, Sciences
et Développement économique Canada applicables aux appa-
reils radio exempts de licence. L’exploitation est autorie aux
deux conditions suivantes :
(1) L’appareil ne doit pas produire de brouillage;
(2) Lappareil doit accepter tout brouillage radioélectrique subi,
me si le brouillage est susceptible d’en compromettre le
fonctionnement.
CAUTION: RISK OF EXPLOSION IF BATTERY IS REPLACED
BY AN INCORRECT TYPE. DISPOSE OF USED BATTERIES AC-
CORDING TO THE INSTRUCTIONS.
Warranty: Warranty for Ajax devices is valid for two years after
the purchase date and does not apply to the supplied battery. If
the device does not work correctly, you should rst contact the
support service—in half of the cases, technical issues can be
solved remotely!
The full t
ext of the warranty is available on the website:
ajax.systems/warranty
User Agreement: ajax.systems/end-user-agreement
Technical support: support@ajax.systems
Manufacturer: “AJAX SYSTEMS MANUFACTURING” LIMITED
LIABILITY COMPANY
Address: Sklyarenka, 5, Kyiv, 04073, Ukraine
www.ajax.systems
ajax.systems/
support/devices/
motionprotect-
outdoor
Frequency range
905 MHz~926.5MHz FHSS
(complies with part 15 of the FCC rules)
Maximum RF output power 6.35 mW
Radio signal range 5,500 ft (line-of-sight)
Horizontal detection angle 90°
Motion detection distance
Adjustable, 3–15 m
when installed at 3.3 ft height
Power supply 2 х CR123A, 3 V
Operation from battery Up to 5 years
External power supply support 5 – 28 V DC, 200 mA
Operating temperature range From -13° to 140°F
Ingress protection IP55
Operating humidity Up to 95%
Dimesions 7.2 х 2.76 x 2.56 ″
Weight 11.36 oz

Summary of content (1 pages)