User's Guide

ManualsBrandsAITOSEE ManualsElectronicsvision sensor

SENTRY 2 Manuals

WiFi Firmware Developing User Guide

V1.1

Sentry2 has an ESP8285 WiFi chip, adopts the same kernel as ESP8266, which can

be programmed by Arduino IDE. This paper will introduce how to configure ESP8285

Arduino development environment and how to upload firmware.

Download and install Arduino IDE：

https://downloads.arduino.cc/arduino-1.8.19-windows.exe

Run Arduino IDE and Open “File” >“Preference”

Input the URL to “Additional Boards Manager URLs” and click “OK”

http://arduino.esp8266.com/stable/package_esp8266com_index.json

AITOSEE.INC

Summary of content (7 pages)

PAGE 1
SENTRY 2 Manuals WiFi Firmware Developing User Guide V1.1 Sentry2 has an ESP8285 WiFi chip, adopts the same kernel as ESP8266, which can be programmed by Arduino IDE. This paper will introduce how to configure ESP8285 Arduino development environment and how to upload firmware. Download and install Arduino IDE： https://downloads.arduino.cc/arduino-1.8.19-windows.exe OS EE .
PAGE 2
SENTRY 2 Manuals Open“Tools”>“Board”>“Boards Manager” AI T OS EE .
PAGE 3
SENTRY 2 Manuals AI T OS EE .
PAGE 4
SENTRY 2 Manuals Connect Sentry2 to PC via an USB-TypeC cable. Open “Tools” and do seme settings as shown in the bellow Buildin Led：“4” CPU Frequency：“80MHz” or “160MHz” Upload Speed：“57600” Reset Method：“no dtr (aka ck)” AI T OS EE .
PAGE 5
SENTRY 2 Manuals Push the Stick button downward and hold it(NOT ENTER Press), Click “upload” to start compiling and uploading, hold the Stick button downward until the screen shows the xx% progress. 1. Push and hold the Stick downward AI T OS EE .I NC 2.
PAGE 6
SENTRY 2 Manuals Wait firmware uploading until 100% Restart the Sentry and runs the “Custom” vision, the Blue WiFi LED will be keep bright and the Custom LED will be blink. Support：support@aitosee.com AI T OS EE .I NC Sales：sales@aitosee.
PAGE 7
SENTRY 2 Manuals FCC Caution： This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. OS EE .