INTRODUCTION Dear Cornerstone | Caution. Features TRANSMITTER AND RECEIVER Parcel Controls and Features Structure of the System SETTING UP THE SYSTEM How to Transmit Audiometer from your VIR How to Receive wireless Audio/Video on your TV if you want to Use the Antenna Cable...
DEAR CUSTOMER, CAUTION FEATURES A we congratulate to your new wireless audio/video sender and we are glad that you have decided for the MBO VFS 1000 from MBO®, The product vou have bought is state of the art, of highest quality and has many advanced features. Please read the operation manual in order to familiarize yourself with ail the possibilities of your MBO FYS 1000. Fallow the instructions in order to ensure reliable operation arid a long service life of the appliance.
The System is 3 wireless audiovisual sender that uses advanced wireless communication technology to deliver consistently sharp audio and video up to 30D meters away. By transmitting at 8 very high frequency {2.4 GHz or 2.4 billion cycles per second), the Compliant, The system avoids the crowded 900 MHz band used by many cordless telephones and other wireless audiotape transmitters. fs superior quality is due to wide-band FM rather than AM signal modulation, .
IMPORTANT SAFETY PRECAUTIONS CAUTION NOTE prevent fire or shock hazard, do not expose this product to fain or moisture. Do not use near a bath tub, basin, kitchen sink, or laundry tub, in a wet basement, ar near a swimming pool. « To avoid electrical shack, do not open this product. « This product should be operated using only the power supply included with it or provided as an accessory. + Do npt overload wall outlets and extension cords as this can result in the risk of fire or electric shack.
PANEL CONTROLS AND FEATURES fig. 1 The following Illustrations show the names of each component, button ang switch connector on the transmitter and receiver, Front view Lh anteing sends anti reeves Dictionary 3.
STRUCTURE OF THE SYSTEM fig.
HOW TQ TRANSMIT AUDIOMETER FROM YOUR VCR 1. Check the spelling of Cinch-Cart cable to the AV jacks on the transmitter and to the Cart connector on the back of your VCR, Be sure the colors of plugs match the colors of fucks on both the VCR and the transmitter. 2. Plug one end of the power adapter into the back of the transmitter and the other end into any 230-volt wall outlet {or 120-volt). Use only the adapter provided. ' Caution: Make sure the SARNOFF switch 5 in the OFF position before connection. 3.
HOW TO RECEIVE WIRELESS AUDIOMETER ON YOGURT IF YOU WANT TO USE THE ANTENNA CABLE There are two ways to receive wireless audiovisual signals on your remote TV (TV in another location such as in bedroom, kitchen), Connect the receiver directly to the remote TV.
Connecting Transmitter ta VCR with Cart Cable fig. 3 To Poser Cutler Start Cable (TRANSMITTER) fig.
Connecting Receiver to TV with Cart Cable or Antenna Cable 75 ohm antenna coaxial cable fr must be purchased Connecting Receiver to TV through VCR with Cart Cable or Antenna Cable Receiver 25 BAHIA Coma! Cable ™ Mast be porn = : fig. 5 Tir Power utter 230 RECEIVER) fig.
Connecting Receiver to TV with Cinch Cable or Antenna Cable 75 ohn antenna coaxial cable fracas be purchased) oes thn coal Connecting Receiver to TV through VCR with Cinch Cable or Antenna Cable To Power Quiet RCA AV Cable 7 Hos 750MM Conical § Cable pi) wv RCA AY Cable, ust be purchased) VCR
CONNECTING RECEIVER TO REMOTE TV THROUGH VCR This setup enables you to record transmitted audio and video on your remote VCR and also enjoy the picture and sound on a remote TV at the same time, 1. Check the spieling of Cinch-cart cable to the AN jacks on the receiver and 10 the Cart connector on the back of your VCR, Be sure the colors of plugs match the colors of jacks on both the VCR and receiver, 2.
REMOTE CONTROL The additional 1-sending head enables you to conduct radio signals of a remote control from transmitter to receiver and therefore 2.4. to control VCR, Sat-Receiver atc. You have to make sure 1o use the cremate control of the equipment which is 10 be remotely controlled, Connecting: +. Connect the IR-Sending Head contained in the extent of supply to the IR-Jack of the transmitter, 2.
ORIENTING UNITS FOR OPTIMAL PERFORMANCE Caution: The system should be placed on a flat, stable surface to prevent damage to it from falling. For uneven or slippery surfaces, such as the top of your Tv, audiometer equipment, or entertainment center. For optimal performance, both the audiovisual should pe carefully oriented as described below.
ATTENTION A Orientation € ABE. 12 Bartender Receiver (Side View) Transceiver {Gide ew} In most situations, the flat curved face of the antennas on both the transmitter and receiver should be facing ong another and perpendicular {a1 a right angle) 10 an imaginary line drawn between the two units. Three examples are shown Fig-1, Fig-2 and Fig-3. Since all homes are different, for optimal reception, additional slight pivots of rotations may be necessary.
TR: Ie} Please read this owner's manual carefully and follow TROUBLESHOOTING the steps described in it, if you still have difficulties, consult the following table. Jt will guide you through the most common problems and their solutions.
SPECIFICATIONS DESCRIPTION OF CONTENTS TRANSMITTER: Output Level Operating frequency Modulation Video Input Level Audio Input Level video input impedance Audio Input impedance Popover Consumption Dimensions Weight RECOVER: Output level Power Consumption Remote Control Transmitter Frequency : Dimensions ‘Weight $0 dB micrometeorite at 3 meters complies with FCC, BIT 2,4 tn 2.4835 GHz Fi {video and audio) 1 pop (75 ohm) 1% pen (600 phi) 75 ohm £00 whm vd, 300 mA app. 12.