INSTRUCTIONS MANUAL FEDERAL COMMUNICATIONS COMMISSION . INTERFERENCE STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
AVOID OF ELECT] DO NOT OPEN Do not expose the product to the rain or fire. Do not use any power supply not approved by the company. Safely precautions 1. 2. Whig manual will show you how to mount and use it 3. 4. When cleaning the product, turn it off first. Use a clean soft cloth Read this manual carefully before you use the product. Please ch serve all the warnings in this manual. moistened with a little bit of water to clean it. .
Content: Connections of the receiver -. Packaging and accessories «rxemmmroremn references eee . Features and functions of the transmitter and receiver Aligning one transmitter With one receiver «wr mmmemwesmrarmnn . Aligning multiple transmitters with one receiver . Channel and switch-over time selection 7. stand an the table or mount on the ball =r=rmmnrmmsmmsosme 8.7T10UBIE SHOOING scr mmm eee omens sn 9.
1.
2. Features and functions of the transmitter and the receiver The transmitter AWT951 Tx: Antenna (2)Optical View Finder (cameramen {mimic {5)Power on indicator (8)Battery Cover (7)Holding Belt ’ (Bic ~ch4 switch on/off Button {10)AV Out Jack 8 : {11)Input Socket $e {12)Stand Socket 1 11 12 The receiver AWV 325 Rx (AWV32X series option): Built in 2 GHz antenna Sends or receives Audio Video signals.
Aligning one transmitter with one receiver (1) Turn the channel switch on the back of the transmitter to channel 1, and then turn the power switch to "ON". Make sure the indicator is on | Turn on the power switch of the receiver. Turn the channel switch to position 1 Connect the A/V signal of the receiver with the line to TV ora monitor. (Refer to Connections of the receiver). Now you should be able to see the image from the monitor or the TV set, talk through the microphone, and hear voices.
6. Channel and switch-over time selection The Video Sender has two operating modes: (1) Permanently set to receive a specific Channel. (2) Switchable between the selected Channels within specified time intervals. This feature is required, for example when the Receiver is used with several radio monitoring cameras. * Channel switch (rear) Four Channel switches (1 to 4) for selecting the receiver Channel.
Stand on the table or mount on the wall {1} Stand on the table: TT Screw the camera AWT951 on the stand and put on the table to obtain the best view. + Adjust the direction vertically or horizontally. 2) Mount on the wall : « Mount the camera AWT851 on the wall as the drawing. + Adjust the direction vertically or horizontally.
8. Trouble-shorting (1) No picture or sound I. Make sure the power supply switches on the back of the transmitter and the receiver are both in the “ON” position. Il. Check correct position of ail the connectors and plugs il. Make sure the transmitter and the receiver are on the same channel. {2} Interruptions in image and sound I. Adjust the transmitter and the receiver to closer position, Il. If a microwave oven or elector-magnetic oven is in use, turn it off and try the product again. fl.