User Instructions

ManualsBrandsAirtraq ManualsElectronicsATQ-032

1 of 6

AIRTRAQ – VIDEO WIRELESS RECEIVER

Model - A-303 and ATQ-303

INSTRUCTIONS

INDEX

1. DESCRIPTION AND INDICATIONS

2. COMPONENTS

3. VIDEO WIRELESS RECEIVER OPERATING INSTRUCTIONS

3.1 Receiver Switches, Indicators and jacks

3.2 Battery Charge

3.3 Viewing on a monitor

3.4 Viewing on a Laptop Computer

3.5 Recording

3.5.1. DVD recorder

3.5.2. Laptop computer

4. CLEANING INSTRUCTIONS

5. STORAGE AND TRANSPORT

6. TECHNICAL DATA

7. FCC and ICES-001 Notices and Warning

8. MANUFACTURER’S WARRANTY

Summary of content (6 pages)

PAGE 1
AIRTRAQ – VIDEO WIRELESS RECEIVER Model - A-303 and ATQ-303 INSTRUCTIONS INDEX 1. DESCRIPTION AND INDICATIONS 2. COMPONENTS 3. VIDEO WIRELESS RECEIVER OPERATING INSTRUCTIONS 3.1 Receiver Switches, Indicators and jacks 3.2 Battery Charge 3.3 Viewing on a monitor 3.4 Viewing on a Laptop Computer 3.5 Recording 3.5.1. DVD recorder 3.5.2. Laptop computer 4. CLEANING INSTRUCTIONS 5. STORAGE AND TRANSPORT 6. TECHNICAL DATA 7. FCC and ICES-001 Notices and Warning 8.
PAGE 2
1. DESCRIPTION AND INDICATIONS The Airtraq Video Wireless Receiver (A-303 and ATQ-303) has been specially designed to work as an accessory for the AIRTRAQ Optical Laryngoscope together with the Airtraq Video camera. The Airtraq Video Wireless Receiver should be placed near the external monitor to which it will be connected. When turned on the Wireless Receiver receives automatically the signal from the Airtraq Video camera by Radiofrequency at 2.4 Ghz. 2. VIDEO WIRELESS RECEIVER COMPONENTS 2.
PAGE 3
.2 Battery Charge 1. Connect the Wireless Receiver to the electricity supply. Turn ON main switch located on the back. The receiver battery will automatically start charging its battery. The Receiver battery charge indicators will show the battery charge level. Insert the camera on its slot. The camera will automatically start charging its battery. The Clip-On Camera battery charge indicators on the receiver panel will show the battery charge level. Recharging the camera battery will take around 1 hour.
PAGE 4
The battery of the Clip-On Camera will last, under standard conditions, approximately 3 hours. Once the battery is below 10% of its capacity a RED low battery indicator on the camera will light. The camera can still operate around 20 to 30 minutes while the red indicator is on. The manufacturer recommends recharging the battery of the camera as soon as the indicator turns red. The battery of the Wireless Receiver will last, under standard conditions, for around 6 hours.
PAGE 5
1. Turn the Video Wireless Receiver OFF. 2. Cleaning: Use clean cotton gauze pads that are saturated with the cleaning solution to wipe down the exterior surfaces of the Video Wireless Receiver. Use soft brushes with the cleaning solution to remove any residues from areas that cannot be reached with the gauze pads. Be sure to remove all visible contaminant or foreign matter. Be careful to keep running liquid off the surfaces. The following cleaning solutions may be used: a. Enzymatic Cleaning Solutions (e.
PAGE 6
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.