LORA TX control link (915MHz) AO00059 – User Manual
Table of Contents Table of Contents .................................................................................................................................................... 2 Introduction ............................................................................................................................................................. 3 Specifications .........................................................................................................................................
Introduction The AO00059 LoRa Remote control RF link is a UHF transmitter in the 902-928MHz ISM band. It used for manual control of Airobotics’ Industrial drones during VLOS (Visual Line of Sight) operation. The AO00059 connects to any off the shelf radio control transmitter (such as the Futaba T14SG) via the remotecontrol trainer port. Connection of the AO00059 to the trainer port overrides the remote control’s internal RF transmitter circuitry and disables it.
Specifications Input Voltage 9 -12.6VDC Input current 300mA (Max) Internal RF Module Microchip RN2903 + CML Micro CMX901 Tx Frequency 902-928MHz OTA Bandwidth 500Khz Tx Power 20dBm Power Spectral Density 8dBm/3kHz (Max) Modulation Type Chirp Spread Spectrum Encryption AES256 (Optional) Safety Features RF Carrier Sense, Loss of Signal Alarm, Low Battery Alarm Antenna Connector SMA (50 Ohm) Power Connector XT60 Data Connector Switchcraft: EN3L6FX Antenna Types Taoglas: FW.95.B.SMA.
Installation Manual Warning: This device must be professionally installed by Airobotics certified technician Needed materials: • AO00059 LoRa transmitter module • Antenna (FW.95.B.SMA.M/ S463AM-915) • Remote control – Futaba T14SG for example • 3S LiPo battery with XT60 connector • Trainer port to LoRa cable • Thread-lock - Loctite 243(Airobotics P/N: 001339) Connection instructions: 1.
2. Connect the LoRa module and battery to the back of the remote control using dual-side adhesive tape. 3. Connect the Trainer cable to the Remote control M.AO00059-Rev.
4. Connect the trainer cable to the LoRa module M.AO00059-Rev.
5. Connect the battery to the LoRa module, this will power up the AO00059 and will start transmitting the remote-control trainer output. Warning: It's forbidden to connect any device to the USB port while the AO00059 is transmitting. M.AO00059-Rev.
FCC Compliance Statement This device has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in residential installations. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio and television reception.