User's Manual

AGN3022UB-11
802.11b/g USB Radio
Installation and User Guide
Product Labeling
The AGN3022UB-11 radio transmitter module is authorized only for use in a device where the antenna
may be installed such that 20 cm can be maintained between the antenna and the users. End-user products
containing AGN3022UB-11 modules MUST have affixed to their labels the following phrase:
This product contains FCC ID: SA3-AGN3022UB1100 module
Product Usage
This device is intended only for OEM/ODM integrators under the following conditions:
1. The antenna must be installed such that 20 cm is maintained between the antenna and users.
2. The transmitter module may not be co-located with any other transmitter or antenna.
3. Use only authorized antenna(s) as described in the FCC filing under FCCID:SA3-AGN3022UB1100
The OEM/ODM integrator is responsible for testing their product for any additional compliance mandates
required when this module is installed within an end-user product.
i IMPORTANT NOTE: In the event that these conditions cannot be met,
then the FCC authorization is no longer considered valid and the FCC ID
number cannot be used on the final product and thus the OEM/ODM
integrator will be responsible for re-evaluating the end product (including
the transmitter) and obtaining a separate FCC authorization.
Product Documentation
Following RF exposure information shall be supplied in end-users manual for products containing the
AGN3022UB-11:
IMPORTANT NOTE:
To comply with FCC RF exposure compliance requirements, the antennas
used for this transmitter must be installed to provide a separation distance of
at least 20 cm from all persons and must not be co-located or operating in
conjunction with any other antenna or transmitter.
Airgo Networks Inc. Page xx of yy January 2006
Airgo Networks Proprietary Information