AIREMAX USER MANUAL PORTABLE AIR CONDITIONER APH10CE APH10CH Read all the instructions carefully before setting up and operating the unit. Keep this instruction manual for future reference.
Contents AIR CONDITIONER SAFETY ............................................................................................... 1 PARTS AND FEATURES ...................................................................................................... 7 INSATALLATION REQUIREMENTS ...................................................................................... 8 INSTALLATION INSTRUCTIONS..........................................................................................
AIR CONDITIONER SAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This is the safety alert symbol. This symbol alerts you to potential hazards that can kill or hurt you and others. All safety messages will follow the safety alert symbol and either the word “DANGER,” “WARNING” or “CAUTION.” These words mean: An imminently hazardous situation.
Disconnect power before servicing. Disconnect power before cleaning. NOTE: Turning off power by pressing the Power button does NOT disconnect the appliance from the power supply. Do not install or use the air conditioner in any area where the atmosphere contains combustible gases or where the atmosphere is contaminated. Avoid any chemicals coming in contact with your air conditioner. Do not store anything directly on top of the air conditioner.
adverse environmental effects. The check shall also take into account the effects of aging or continual vibration from sources such as compressors or fans. Under no circumstances shall potential sources of ignition be used in the searching for or detection of refrigerant leaks. A halide torch (or any other detector using a naked flame) shall not be used.
equipment are removed from site promptly and all isolation valves on the equipment are closed off. Recovered refrigerant shall not be charged into another refrigeration system unless it has been cleaned and checked. Equipment shall be labelled stating that it has been de-commissioned and emptied of refrigerant. The label shall be dated and signed. Ensure that there are labels on the equipment stating the equipment contains flammable refrigerant.
N'utilisez pas de moyens pour accélérer le processus de dégivrage ou de nettoyage, autres que ceux recommandés par le fabricant. L'appareil doit être stocké dans une pièce sans sources d'inflammation en fonctionnement continu (par exemple : flammes nues, appareil à gaz en fonctionnement ou radiateur électrique en fonctionnement. Ne pas percer ni brûler. Sachez que les réfrigérants peuvent ne pas contenir d'odeur.
de réfrigérant nécessitant un brasage est détectée, tout le réfrigérant doit être récupéré du système ou isolé (au moyen de vannes d'arrêt) dans une partie du système éloignée de la fuite. L'azote sans oxygène (OFN) doit ensuite être purgé à travers le système avant et pendant le processus de brasage. Lors de l'effraction du circuit frigorifique pour effectuer des réparations – ou à toute autre fin – des procédures conventionnelles doivent être utilisées.
Lors de l'élimination du réfrigérant d'un système, que ce soit pour l'entretien ou la mise hors service, il est recommandé de faire en sorte que tous les réfrigérants soient éliminés en toute sécurité. Lors du transfert de réfrigérant dans des bouteilles, assurez-vous que seules des bouteilles de récupération de réfrigérant appropriées sont utilisées. Assurez-vous que le nombre correct de cylindres pour contenir la charge totale du système est disponible.
1. 2. 3. 4. 5. 6. 7. 8. Control Panel Air Discharge Louvers Caster Remote Control Holder Side Handle Power Cord Storage Air Filter Center Drain Cap 9. 10. 11. 12. 13. 14. 15. Lower Drain Cap Remote Control Round Connector Exhaust Hose Adapter Window kits Window kits screw(butterfly nut) INSATALLATION REQUIREMENTS TOOLS AND PARTS Gather the required tools and parts before starting installation.
ELECTRICAL REQUIREMENTS ! WARNING Electrical Shock Hazard Plug into a grounded 3 prong outlet. Do not remove the ground prong from the power cord plug. Do not use an adapter. Do not use an extension cord. Failure to do so can result in death, fire or electrical shock. POWER SUPPLY CORD Wiring Requirements • 115 Volt, 60Hz, 15-amp fused grounded 3 prong outlet • The use of a time-delay fuse or time-delay circuit breaker is recommended. • Use a dedicated circuit only.
Remove packaging materials. Save the carton and the foam packaging for storing the air conditioner when not in use. NOTE: There are NO packing materials inside the air conditioner to remove—Do Not open the cabinet. Properly dispose of/recycle all packing material. Handle the air conditioner gently. Keep the air conditioner upright and level. Do not set the air conditioner on its side, front, back or upside down. STEP 2 - TWIST THE EXHAUST HOSE CONNECTOR ONTO EXHAUST HOSE A.
Vertical Slide Window Horizontal Slide Window B. Take out the butterfly nut from the user manual’s bag, and disassemble the screws in the following directions. C. Lock the butterfly nut on panel A, and do not lock the butterfly nut tightly, keeping the spacing of 2.5mm. D. Connect with panel B, adjust the panel(s) to the width or height of the window as shown.
E. Fasten the butterfly nut to fix the window slide set. STEP 5 - COMPLETE INSTALLATION Close the window as far as the window slide set, so this covers the window opening completely. Place the device at least 50 cm away from walls and other objects. NOTE: Some window installations may require the extension panels to be trimmed. Slide the adapter downwards and assure adapter installed in good position. Assure the slant panel direction to match seal-plate direction.
CONTROL PANEL BUTTONS A. TIMER BUTTON Program a time from (1-hour to 24-hours) for the air conditioner to turn Off or On. When a Time Delay is programmed, the Timer indicator light will illuminate. While the air conditioner is operating: 1. Press the Timer button. 2. Press the Up/Down arrow buttons to select the number of hours you want the air conditioner to continue to operate before turning Off. While the air conditioner is off: 1. Press the Timer button. 2.
displaying the temperature in ºC or ºF. The corresponding indicator will illuminate. E. MODE BUTTON Press the Mode button to toggle among the operating options. The corresponding indicator will illuminate: Heat (on some models)- Heats the room to the set temperature Cool – Cools the room to the set temperature Dehum – Reduces the humidity in the room Fan – Circulates the air in the room without cooling F. POWER BUTTON Turns ON/OFF power to the air conditioner.
clothes, please rinse with plenty of water as soon as possible; if you find a leak, please do not use the remote control. If you swallow the battery liquid, rinse your mouth and seek medical attention as soon as possible. The chemical substances in the battery may burn or cause other health hazards. SAFETY PROTECTIONS 1.
Notes: Protect the drain cover and water stopper properly. Move the unit carefully to avoid the leakage it is necessary. Tilt the unit slightly backwards when draining. Block the drain hole as soon as possible before the tray is full if it cannot hold all water in the unit to prevent the water leakage and wet the floor or carpet. Water stopper and drain cover must be tightly installed, to avoid new condensate to wet the floor or carpet when the unit re-starts working. CONTINUOUS DRAINAGE 1.
- Removal of filter at back panel is at priority then for the filter at side panel, to avoid any twist or damage to filter. - Do not squash or hit the mesh with sharp objects or brush. - Do not use the appliance without installing the filter. INTERNAL WATER TANK The Water Full indicator illuminates, when the internal water has filled with condensate water. To Empty the Internal Water Tank: 1. Unplug or disconnect power. 2.
TROUBLESHOOTING First try the solutions suggested here to possibly avoid the cost of a service call. Trouble Cause Solution Connect the unit to a live socket and Power supply failure turn it on. Water-full and its icon lighting The unit fails to start up Drain the water stored in the unit.
WARRANTY Portable air conditioner limited warranty Any repair, replacement, or warranty service, and all questions about this product should be directed to customer service center. The warranty commences the day the product is purchased and covers up to a period of 1 year (12 months) for parts (manufacturing defects only). Exclusions: This warranty does not apply to the below: If the appearance or exterior of products has been damaged of defected, altered or modified in design or construction.