Installation Instructions

IMPORTANT SAFETY AND INSTALLATION PROCEDURES
READ AND SAVE THESE INSTRUCTIONS
READ COMPLETELY BEFORE INSTALLATION
CAUTION: “For General Ventilation Use Only,
Do Not Use for Exhaust Hazardous or Explosive Materials and Vapors.”
-The combustion airflow needed for safe operation of fuel-burning equipment may be affected by this
unit’s operation. Follow the heating equipment manufacturer’s guideline and safety standards such as
those published by the National Fire Protection Association (NFPA) and the American Society for
Heating, Refrigeration and Air Conditioning Engineers (ASHRAE) and the Local Code Authorities.
CA
UTION: THIS UNIT HAS AN UNGUARDED IMPELLER. DO NOT USE IN LOCATIONS READILY
ACCESSIBLE TO PEOPLE OR ANIMALS.
W
ARNING: TO REDUCE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS,
OBSERVE THE FOLLOWING:
-Use this unit only in the manner intended by the manufacturer. If you have questions, contact the
manufacturer.
-Before servicing or cleaning the unit, switch power OFF at the service panel and LOCK service panel
to prevent power from being switched on accidentally. When the service disconnecting means cannot
be locked, securely fasten a prominenet warning device, such as a tag to the service panel.
-Installation work and electrical wiring MUST be done by qualified person(s) in accordance with all
applicable codes and standards, including fire-rated construction.
-When cutting or drilling into wall or ceiling, do not damage electrical wiring and other hidden utilities.
-Ducted fans must always be vented to the outdoors.
-If this unit is to be installed over a tub or shower, it must be marked as appropriate for the application.
-NEVER place a s
witch where it can be reached from a tub or shower.
-NEVER install a whole house attic fan on ceilings less than seven (7) feet above the floor.
No. 18593
[e-mail] • www.airvent.com • 800-AIR-VENT (247-8368)
4117 Pinnacle Point Drive
•
Suite 400
•
Dallas, Texas 75211