Bluetooth Mono Headset USER MANUAL FCC ID: AYBACB-BH119A Model : ACB-BH119A
Contents 1. Introduction Bluetooth wireless technology 2. Get started Overview Chargers and batteries Switch the headset on or off Pair the headset with A compatible phone Disconnect the headset From the phone Reconnect the paired headset to your phone Troubleshooting 3. Basic use Call handing Adjust the earphone volume 4. Battery information 5. Care and maintenance 1.
2. Get started Over view: Before you can start using the headset, you must charge the battery and pair the headset with a compatible phone. Note: Parts of the headset are magnetic, Metallic materials may be attracted to the headset .Do not place credit cards or other magnetic storage media near the headset, because information stored on them may be erased . Charger and batteries Check the model number of any charger before using it with this device.
name appears in the phone menu where you can view the currently paired Bluetooth devices. Disconnect the headset from the phone To disconnect the headset from your phone(for example, to connect the phone to another Bluetooth device), do one of the following: ·Switch off the headset. ·Disconnect the headset in the Bluetooth menu of your phone. ·Move the headset more than 10 meters(30 feet) away from the phone. You do not need to delete the pairing with the headset to disconnect it.
4. Battery information Your device is powered by a rechargeable battery. The full performance of a new battery is achieved only after two or three complete charge and discharge cycles. The battery can be charged and discharged hundreds of times, but it will eventually wear out. Recharge your battery only with compatible chargers designated for this device. Unplug the charger from the electrical plug and the device when not in use.
any enhancement. If any device is not working properly, take it to the nearest authorized service facility. IMPORTANT REGULATORY INFORMATION This device complies with Part 15 of the FCC Rules: Operation is subject to the following two conditions: 1. This device may not cause harmful interference and 2. This device must accept any interference that is received, including any interference that may cause undesired operation.