User's Manual

SCLCT06M User’s Manual

Power ON/OFF

：

Turn On

：

Press the button -> You will hear "POWER ON" when powering on

(the left and right ears should be turned on separately)’

Turn Off: You must disconnect the device or mobile phone before turning off

-> Press and hold the button to hear "Beep~Beep Beep", then release to hear

power off

How to re-pair:

Our headset will remember the phone or device.

To connect with the new device -> Make sure you hear power on -> Press and

hold the button and you will hear "Beep~BeepBeep~ BeepBeepBeep" and

then release it to find it on the phone.

Speaker

Driver unit:30mm, dome type(CCAW Voice Coil)

Impedance: 24ohm at 1kHz

Sensitivity:98dB/mW

Frequency response:10Hz-24000Hz

PAGE 1
SCLCT06M User’s Manual Power ON/OFF： Turn On：Press the button -> You will hear "POWER ON" when powering on (the left and right ears should be turned on separately)’ Turn Off: You must disconnect the device or mobile phone before turning off -> Press and hold the button to hear "Beep~Beep Beep", then release to hear power off How to re-pair: Our headset will remember the phone or device.
PAGE 2
FCC Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.