Parts List/Tune Up Info

Tune-up Procedure
During manufacturing each product will be individually calibrated.
The measurement is done in a fully calibrated setup, which is based on Anritsu MT8870A, or RS
CMW500, or iTest WT108, or Litepoint IQxstream.
Furthermore, the maximum power is verified afterwards in a call measurement on three channels (low, mid
and high).
Procedure:
1. Set the module to operational voltage and on one certain channel in a special service mode by means
of company proprietary software.
2. The actual power is measured at minimal and maximum power levels.
3. The gain factors of each individual module are adjusted via the Board-test SW using automatic
adjustment arithmetic until the target value is met.
4. The tune-up target value is below:
LTE 2/4/12/66/71 : 23 dBm [- 2 dBm ~ + 2 dBm]
The appropriate gain control settings are stored in RF table (a special section in Flash marked with Read only
and untouchable for end user) each module individually (for each power level).
The user has no possibility to change these settings later on.