User Manual

HDMI Extender Over Network Cable

User’s manual

IMPORTANT SAFETY INSTRUCTIONS

：

1. Do not mix up HDI to RJ45 sender and RJ45 to HDMI receiver before installation .

2. DO not hot plug when it is working.

3. Use DC5V power supply only.Make sure specification matched if using adapters not supplied by factory.

 PACKAGE CONTENTS

1.HDMI to RJ45 sender TX*1pcs 2.RJ45 to HDMI receiver RX*1pcs

3.DC5V/1A *2pcs 4. User manual*1pcs

5. IR blaster extension cable *1pcs 6. IR receiver extension cable*1pcs

Installation Requirements

1. HDMI source device(computer graphics card, DVD,PS3, HD monitoring equipment etc).

2. HDMI display device like SDTV, HDTV, projector with HDMI port.

3. UTP/STP cat6/6A/7 cable, follow standard IEEE-568B.

 Panel Description

1. HDMI to RJ45 transmitter

PAGE 1
HDMI Extender Over Network Cable User’s manual IMPORTANT SAFETY INSTRUCTIONS： 1. Do not mix up HDI to RJ45 sender and RJ45 to HDMI receiver before installation . 2. DO not hot plug when it is working. 3. Use DC5V power supply only.Make sure specification matched if using adapters not supplied by factory.  PACKAGE CONTENTS 1.HDMI to RJ45 sender TX*1pcs 3.DC5V/1A *2pcs 5. IR blaster extension cable *1pcs 2.RJ45 to HDMI receiver RX*1pcs 4. User manual*1pcs 6.
PAGE 2
1 DC5V power input 2 HDMI signal input 3 IR signal output to connect ith blaster extension cable 4 Reset 5 RJ45 signal output 6 HDMI signal indicator led it lights on all the time with HDMI signal input, flashes with no signal input. 2.RJ45 to HDMI receiver 1 reset 2 RJ45 signal input 3 RJ45 indicator led it lights on all the time with HDMI signal transmission, flashes with no signal transmission.
PAGE 3
2. Connections Connection instruction: 1) Connect TX HDMI input with source device HDMI output.Connect TX HDMI output with HDTV HDMI input. 2) Connect TX CAT6 with RX CAT6. 3) Connect RX HDMI output with HDTV HDMI input. 4) Power on the device and it works. 五、FAQ Q: No image output or audio and video display is not normal? A: 1)Adjust RX “RESET” button to reset the device. 2)Try shorter network cable to reconnect.
PAGE 4
A: 1)Press RX “RESET” button to reset the device. 2)Make sure HDMI cable is well connected with TV. 3)Make sure the network cable is fine copper wires.