Product Manual

#745 Striping Stick
Operating Instructions
The Striping Stick is designed for use with inverted striping paint. The can should only be used
in an inverted position.
1. The Wheel will sit on the left side of the Stick when resting on the ground.
2. Shake the can according to the label instructions and remove the cap.
3. Align the Tip (T-shaped oval) with the oval hole in the metal plate on the Stick.
4. Insert the can into the Can Holder until it rests on the stops.
5. The Retention Clip will rest on the bottom rim of the
can preventing movement when the tip is activated.
6. To remove the can, push the Retention Clip to
the shaft with thumb. Pull can from holder with
opposite hand.
Aervoe Industies, Inc.
1100 Mark Circle, Gardnerville, NV 89410 • 800-227-0196
www.aervoe.com • [e-mail]
3/18/CS
Can Holder
Trigger
Wheel
Retention Clip