User's Manual

ManualsBrandsAerohive Networks ManualsElectronicsAP Router

Operating Instructions Manual

Model Name: BR200-WP

Model No., BR200-WP

AC/DC power Adapter Rating: 48Vdc, 1.25A

Operating Temperature: 32 to 104 degrees F (0C to 40 degrees C)

Storage Temperature: -4 to 158 degrees F (-20 to 70 degrees C

Relative Humidity: Maximum 95%

Contact for software questions:

info@aerohive.com

Phone: 408-510-6100

Needed Equipment:

Ethernet hub.

Laptops

AP login information:

Serial connection: 9800, 8, N, 1, no flow control

Password: aerohive

Must have the Ethernet port connected so the EUT gets active link.

Must enter line commands to set channel, power and mode.

Wifi1 – 5GHz radio

Wifi0 – 2.4GHz radio

In the instructions below, enter the correct wifi1 or wifi0 for the appropriate band you are

testing.

To display available channels:

show interface <wifi0 | wifi1> channel

To set channel:

interface <wifi0 | wifi1 > radio channel XX <- 2.4GHz or 5G to channel XX

To set power:

Summary of content (4 pages)

PAGE 1
Operating Instructions Manual Model Name: BR200-WP Model No., BR200-WP AC/DC power Adapter Rating: 48Vdc, 1.25A Operating Temperature: 32 to 104 degrees F (0C to 40 degrees C) Storage Temperature: -4 to 158 degrees F (-20 to 70 degrees C Relative Humidity: Maximum 95% Contact for software questions: info@aerohive.com Phone: 408-510-6100 Needed Equipment: Ethernet hub.
PAGE 2
interface radio power XX <-- sets 2.4GHz/5G radio to power XX, note if power XX is greater than the systems internal power limit for japan, it will set power to the limit To change between 20MHz and 40MHz operation, need to load/change the operation radio profiles: radio profile 11na channel-width 40-above <-- will set the 5GHz radio to 40MHz operation, with the extra 20MHz emission located above the current channel.
PAGE 3
To start continuous transmission: _test interface wifi tx-chain-mask YY cont-tx XX payload-size 1500 Must use _ before test Must set channel, power and bandwith first YY = 0x1 for single chain, or 0x3 for both chains (use this!) XX = data rate in 500kB/s. (For legacy modes – take the normal data rate and double it, for example, 802.11b 1Mbs/s – enter in 2, for 802.11g, 11Mb/s – enter in 22; or enter in MCS#) Examples: 802.
PAGE 4
DFS Instructions Need: DFS client laptop EUT Serial Laptop (192.168.1.2) – VLC server ethernet ethernet DFS client (192.168.1.3) POE AC ENET Switch Setup the DFS client to fixed IP address: 192.168.1.3 Set the channel and bandwidth using the radio commands shown previously Once the client laptop associates with the AP, confirm that you can ping the laptop wired to the AP.