Installation Instructions

Information The information contained in this manual and the accompanying

software programs are copyrighted and all rights are reserved by

AEROCOMM, Inc. AEROCOMM, Inc. reserves the right to make

periodic modifications of this product without obligation to notify

any person or entity of such revision. Copying, duplicating, selling,

or otherwise distributing any part of this product without the prior

consent of an authorized representative of AEROCOMM, Inc. is

prohibited.

All brands and product names in this publication are registered

trademarks or trademarks of their respective holders.

FCC NOTICE

ANTENNA WARNING

Mfr Model Freq Gain Type Connector Dimensions Installation

1 Centurion WXE2400 2.4-2.5 2dBi Omni MMCX <2.25" Integrated

2 Maxrad MFB24008 2.4-2.5 8dBi Omni N-F 17" Professional

20cm min

3 Maxrad BMMG24000MMCX6' 2.4-2.5 unity Omni-mobile MMCX 1.75" Professional

20cm min

4 Maxrad BMMG24000RPSMA12' 2.4-2.5 5dBi Omni-mobile R-SMA-M 9" Professional

20cm min

5 AeroComm NZH2400 2.4-2.5 1dBi Omni Integrated 1"x0.3" Integrated

6 Maxrad MP24013FC 2.4-2.5 13dBi Panel TNC-F 8.7x7.9x1.1 Professional

20cm min

7 Maxrad MUF24005 2.4-2.5 5dBi Omni-Mobile R-SMA-M 8.75" Professional

20cm min

8 Centurion WXR2400SMRP 2.4-2.5 2dBi Omni R-SMA-M <2.25" User

WARNING: This device complies with Part 15 of the FCC Rules. Operation is subject to the following

two conditions: (1) this device may not cause harmful interference and (2) this device

must accept any interference received, including interference that may cause undesired

operation.

WARNING: This device has been tested with an MMCX connector with the antennas listed below.

For the purpose of FCC RF Exposure Compliance, the Original Equipment Manufacturer

(OEM) must ensure professional installation of Antennas 2, 3, 4, 6 and 7 by signing the

PROFESSIONAL ANTENNA INSTALLATION AGREEEMENT. Any antenna not in the

following table must be tested to comply with FCC Section 15.203 for unique antenna

connectors and Section 15.247 for emissions.

PAGE 1
Copyright Information/FCC User’s Notice Copyright Information Copyright © 1999 AEROCOMM, Inc. All rights reserved. The information contained in this manual and the accompanying software programs are copyrighted and all rights are reserved by AEROCOMM, Inc. AEROCOMM, Inc. reserves the right to make periodic modifications of this product without obligation to notify any person or entity of such revision.
PAGE 2
LABELING REQUIREMENTS WARNING: The Original Equipment Manufacturer (OEM) must ensure that FCC labeling requirements are met. This includes a clearly visible label on the outside of the OEM enclosure specifying the AeroComm FCC identifier for this product as well as the FCC Notice above.