Installation Manual

ManualsBrandsAeon Stands and Mounts ManualsAccessories & SuppliesAeon Stands and Mounts Full Motion Wall Mount with 29-Inch Extension for 32 to 65-Inch TV

23" - 55"(58-140cm)

70lbs (31kg) max.

Warning

The wall structure must be capable of supporting at least a maximum weight of 70lbs

(31kg) for 23"-55" televisions. If not, the wall must be reinforced. Proper installation

procedure by a qualified service technician, as outlined in the installation instructions,

must be adhered to. Failure to do so could result in serious personal injury, or even

death.

Safety measures must be practiced at all times during the installation of this product.

Use proper safety gear and tools for the installation procedure to prevent personal

injury.

Prior to the installation of this product, the installation instructions should be read and

completely understood. The installation instructions must be read to prevent personal

injury and property damage. Keep these installation instructions in an easily accessible

location for future reference.

A secure structure must support the weight or load of the display, When mounting

to a wall that contains wooden studs, dead center of the wooden stud must be

confirmed prior to installation.

Do not install on a structure that is prone to vibration, movement or chance of

impact. Failure to do so could result in damage to the display and/or damage to

the mounting surface.

Do not install near heater, fireplace, direct sunlight, air conditioning or any other

source of direct heat energy. Failure to do so may result in damage to the display

and could increase the risk of fire.

least two qualified people should perform the installation procedure. Injury

and/or damage can result from dropping or mishandling the display.

Recommended mounting surfaces: wooden studs and solid-flat concrete. If the

mount is to be installed on any surface other than wooden studs, use suitable

hardware (which is commercially available).

AEON-40112

VESA

100/200/300/400

AEON-40112

Summary of content (4 pages)

PAGE 1
Warning AEON-40112 The wall structure must be capable of supporting at least a maximum weight of 70lbs (31kg) for 23"-55" televisions. If not, the wall must be reinforced. Proper installation procedure by a qualified service technician, as outlined in the installation instructions, must be adhered to. Failure to do so could result in serious personal injury, or even death. Safety measures must be practiced at all times during the installation of this product.
PAGE 2
INSTALLATION 1 INSTALLATION 3 Mark Location of TV Mount (on wooden studs) Mounting to Concrete or Masonry F G 60mm(2.4”) NOTE: If mounting to concrete or masonry please skip to step 3. 10mm(0.39”) NOTE: If mounting to a wooden stud please skip this step and proceed to step 4. 1. Using a stud finder, locate the appropriate wood stud where the mount is to be installed. Level 1. Select the appropriate location where the mount is to be installed and mark the six (6) outer pilot holes. 2.
PAGE 3
INSTALLATION INSTALLATION 5 X Attaching the Adapter Plates TV TV TV TV 7 X Attaching the TV to the Mount TV Option TV TV TV Option A~D a A~D E a E 200mm 8” (200mm) NOTE: This step is necessary for TVs with a 300 x 300 or 400 x 400mm VESA pattern. 1. Place the adapter plates on the back of the TV (with the slotted mounting holes at the top) aligning them with the appropriate VESA pattern.
PAGE 4
INSTALLATION INSTALLATION 9 11 Plastic Covers Installation Adjusting the Display Attach Plastic Covers Snap the plastic cover onto the mount once all cable and wire management has been completed. Post-Installation Leveling The Aeon 40112 features a level adjustment via the 3 screws on the back of the faceplate. Simply loosen these screws and adjust the TV to the proper position. Once the TV is in the ideal location please re-tighten these screws securely. p.6 2.6”- 29.