Installation Guide

B.3 Fixed the adaptor bracket onto the display with
the selected mounting screws, square washers,
and any required spacers.
B.2 Insert Slider plate(M/Nx4) into adaptor rails, then
insert the adaptor bracket into adaptor rail, fix adaptor
bracket and slider plate with four philips head screw
M6*15mm(I)and four metal washers 6(L)using
Philips headcrew driver as shown Fig.4b.
Φ
Metal washers Φ6
Slider plate
Philips head screw
M6*15mm
Adaptor bracket
Adaptor rail
(I)
(M/Nx4)
14.5”
21.5”
Select from
Mounting Screws
Adaptor Bracket
Metal washer
Ø 6L or
fig.4b
Ø
8H
fig. 5
G1
G2
G3
G4
G5
G6
G7
G8
G9
G10
Determine where you want your tv mounted on
your wood stud wall. Note that the center of the
arm of this TV mount will represent the center of
your TV. Choose the appropriate height for your
viewing pleasure. The location you choose must
be between two 16 in on center wood studs .
A1: Now that you have chosen an area. Mark
out an area 14.5 inches wide and 21 inches tall.
Note again the center of this area will be the
center of your TV . Make sure that the vertical
edge lines are located on the inside edge of your
wood studs. Fig.1
A2 : Cut out the drywall in the marked area with the
appropriate tools . Fig.1
A3: Insert the metal in wall box into opening. While
pushing the box against the right stud, mark the location of
holes G1 and G2. Remove in wall metal box.
A4: Pre drill the two marked locations G1 and G2 with a 3/16
inch drill bit.
A5: Insert Metal in wall box into opening. Take two screws
(G) from Bits Bag. Using a wrench tighten screws G1 and
G2. Shown in Fig 2.
A6: Insert Wall mount into In wall metal box. Extend both top
and lower braces until they touch both studs. Hold and mark
location of all holes G3 through G10. Fig.3
A7: Remove wall mount from in wall box. Drill 3/16 inch
holes completely through stud in locations G3 to G10.
A8: Put wall mount back into recessed in wall box. Insert
and tighten all screws using 8 lag screws (G) from bits bag in
location G3 to G10. Fig 3
Caution: Do not tighten screws with impact drill or hammer.
Hand tighten to not cause damage to wood stud and or lag
screw.
B1: Slide the two vertical adaptor brackets into two
vertical adaptor rails. Lay adaptor rails and adaptor
bracket assembly on back of tv set. Note that center of
metal plate will represent center of your TV. Push two
vertical adaptor brackets in and out until they align with
the width of your 4 mounting holes. Now align the bracket
vertically, noting that the center of the metal plate should
be the vertical center of your TV. Fig 4 a
fig.4a
B4: Align the ad adaptor bracket assembly with the 4
mounting holes on the back of your TV. Note that
assembly should be vertically and horizontally
centered with the center of your TV. Fig 5 Select the
appropriate (TV Mounting Screw size – A,B, C or D)
This depends upon the hole and thread size in your
TV. Use a spacer if required. Hand tighten 4 screws
with washers. Do not over tighten as you could
damage your TV .
NOTE: To insure the TV weight is distributed
equally. Make sure A=B and C=D; equidistant.
A
B
C
D
TV center