Aeon Labs Minimote (Z-Wave Remote Controller)
Introduction: The Minimote is a fully functional Z-Wave remote control capable of adding, removing and controlling other Z-Wave devices. Advanced functions include automatic rediscovery of the ZWave network and becoming a secondary or inclusion controller to a SIS gateway in the ZWave network. Direct communication range is 100ft. indoors and 300ft. outdoors.
Minimote Network Functions: • Inclusion-Mode : Adding/Including Z-Wave Devices into the Z-Wave Network 1. Press the button labeled “Include” – The blue LED will blink slowly to indicate that the Minimote has entered Inclusion-Mode. 2. Press the Z-Wave button on the product you wish you add into the network - The blue and red LED will blink quickly to indicate detection of the Z-Wave device being added. 3.
• Creating Scenes (and Removing Z-Wave Devices from Scenes) 1. Press and hold the scene button you wish to configure (top of enclosure) – The blue LED will blink quickly after 1 second to show that it is ready to add/remove a device from the scene. 2. Press the Z-Wave button on the product you wish add/remove (while still holding the scene button from the previous step) - The blue LED on the Minimote will stay solid to indicate the device has entered the scene.* 3.
• Associating Z-Wave Lights/Switches/Gateways to Z-Wave Sensors in the Network 1. Press the button labeled “Associate” – The blue LED will blink slowly to indicate that the Minimote has entered Association-Mode. 2. Press the Z-Wave button on the product you wish the sensor to communicate to The blue LED will blink quickly to indicate detection of the Z-Wave device. 3.
• Shifting the Primary/Master Controller Role to Another Controller in the Same Network 1. In Press the button labeled “Learn” on the other Z-Wave controller to become primary/master - The blue LED will blink to indicate the Z-Wave controller is ready to receive information from another Z-Wave controller.
FCC NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation.