User's Manual

User Manual
What
,
s Included
1. Read the instructions carefully prior to assembly.
2. Check to make sure there are no hidden wires or pipes in wall before drilling.
3. Install screws directly into wall studs or wood.If installing into drywall, use the included anchors. For other wall materials,
consult a professional to obtain the correct hardware.
4. Periodically check allattachment points to make sure they remain fully tightened.
5. This product requires 3 AA batteries (not included). Make sure the polarities are in the right direction when inserting the batteries.
BATTERY CAUTIONS & DISPOSAL INFORMATION
Install only new batteries of the same type.
Do not insert the batteries with the positive and negative polarities reversed.
Do not mix old and new batteries.
Do not mix alkaline, standard (carbon zinc) or rechargeable (nickel cadmium or nickel hydride) batteries.
Remove if product is to be left unused for a long period of time.
Batteries should be recycled or disposed of properly. Check with your local or state solid waste authority for disposal management options.
Screws
Wall Anchors
X 2
X 2
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authorit y to
operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance wit
h the instructions, may cause harmful interference to radio communicatio ns. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or te levision reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Manfactured by Geeknet, Inc.
625 Westport Pkwy, Grapevine TX 76051
Phone: [phone]