WIRELESS DIGITAL ACCESS CONTROL KEYPAD RoHS Compliance DK-2310 Operating Instructions FOR ELECTRIC LOCK AND SECURITY SYSTEM AEI PROTECT-ON SYSTEMS LIMITED www.apo-hk.
TABLE OF CONTENTS .....................................................................................3 INTRODUCTION SPECIFICATIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 INSTALLATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 The Ciruit Board . . . . . . . .
BACK-LIT ON-OFF SELECTION ( Location 9 ) LOCATIONS FUNCTION MODES 9 0 or 1 VALIDATION # CODE FOR BACK-LIT MODE Two codes are available for selection. 0 --- Back-lit OFF ( Default ) No back-lit at all. The keypad consumes less power and results in longer battery life. 1 --- Back-lit ON The keyboard lights up when a key is pressed, which is convenient for the owner at night. The illumination is OFF automatically 10 seconds after the last key is pressed and the keypad is left in rest.
INSTALLATION USER CODE ENTRY MODE - Auto or Manual Mode DK-2310 RED AMBER Plastic Back Box with Battery Case Faceplate + Circuit Module Fixing Frame (Location 7) LOCATIONS ENTRY MODES 7 1 2 VALIDATION # or USER CODE ENTRY MODES Two entry modes are available for owner’s selection. 1 --- Auto Entry Mode -- (Default) The keypad checks the User Code automatically when the number of digits is reached. It is not required to press of the key to confirm.
VISITOR CODES (FOR OUTPUT 1 ONLY) (Locations 5) THE CIRCUIT BOARD The Visitor Codes are temporary codes for operating Output 1 only. They can be programmed as one time codes or codes with valid time limit. The Visitor Codes will be cleared automatically after use if they are one time codes, or, when the allowed time expires. LOCATION 5 VISITOR ID VALID PERIOD 00 or 0 to 9 Selection of high or low beep VISITOR CODE VALIDATION 01 to 99 4-8 DIGITS # VISITOR ID 10 Visitor Codes can be programmed.
POWER UP THE KEYPAD RECORD A SUPER USER CODE ( Location 4) After snapping the 9V battery on the battery clip, the keypad is in the power up delay of one minute and the keypad gives beep sound during the period. It goes to normal operation after the time expired. The power up delay allows the keypad circuit to stabilize and it is also the only time for the keypad to accept the DAP code for setting it into programming mode in case of the Master Code is forgotten.
FEATURE PROGRAMMING OPERATION After setting the system into programming mode, the feature values can be put into the system one by one with the Programming Locations. Programming can be made continuously and it is not necessary to be in order sequence. Just go to the desired location and key in the feature value. After the keypad and keyfob are registered in the receiver it can be used for door release in access control or other controls with the auxiliary channels.
SET SYSTEM IN PROGRAMMING MODE OR REFRESH THE SYSTEM SET SYSTEM INTO PROGRAMMING MODE WITH THE MASTER CODE REFRESH THE SYSTEM WITH THE “DEFAULT CODE” --- 9 9 9 9 The system can be refreshed with the Default Code to clear all the old data. It is necessary to set the system into programming mode to accept the new programming values.