User's Manual

DA-12 RF REMOTE CONTROL KEYFOB

INTRODUCTION

DA-12 is a 4 channel remote control keyfob working on 433MHZ, which is compatible with

the receiver in the DA-2800, DA-2311 and AD-2322 controllers. It has four buttons A, B,

C and D for sending out signals to activate the corresponding four output channels 1, 2, 3

and 4 in the receiver unit.

SPECIFICATIONS

Number of ID Codes : Over 1 Million, Pre-set

Number of Control Channels : 4

a) Channel 1 (Button A) - Activates Output 1 in Receiver

b) Channel 2 (Button B) - Activates Output 2 in Receiver

c) Channel 3 (Button C) - Activates Output 3 in Receiver

d) Channel 4 (Button D) - Activates The Door Chime in Receiver

Operating Frequency : 433 MHZ

Control Distance : 50 Meters Approx. in Open Space

Operation Voltage : 12V Alkaline Battery, Type 27A (Not included)

Weight : 32g

Specifications are subject to change for modifications without notice.

THE ASSEMBLY

LED INDICATOR

FOUR

CONTROL

BUTTONS

THREE

FIXING

SCREWS

FRONT BACK

FRONT BOX

COVER

BACK BOX COVER

CIRCUIT BOARD

CIRCUIT

BOARD

BATTERY

12V 27A

FCC ID: OGJ-D$7;

FCC ID Label & Location

PAGE 1
DA-12 RF REMOTE CONTROL KEYFOB INTRODUCTION DA-12 is a 4 channel remote control keyfob working on 433MHZ, which is compatible with the receiver in the DA-2800, DA-2311 and AD-2322 controllers. It has four buttons A, B, C and D for sending out signals to activate the corresponding four output channels 1, 2, 3 and 4 in the receiver unit.
PAGE 2
EQUIP THE BATTERY DA-12 is supplied without battery. It is required to equip a 12V, type 27A alkaline battery in it before use. 1) Un-screw the three fixing screws on the back of the unit. 2) Take out the back cover carefully to prevent damage of the circuit board that is stuck on it. 3) Equip a 12V, type 27A alkaline battery in it with correct polarity as indicated. 4) Hold the back cover and circuit board assembly firmly and put them back on the front box in the right position.