Please read and keep your operating instructions The information in this booklet will help you to get the best from your very efficient Lava therm tumble dryer. Do not call out a service engineer for any user related information contained in the booklet such challis not free of charge.
Your Lava therm Front Fig. Worktop removals) Fig. 1/Z) Fluff filter Fig. 1/Z) Rating plate (E-No. and F-No.} Fig. 142) Cover to fluff filter (ift up) Fig. 148} Programmer chart Fig. 14B) Air vent Fig. 17) Access flap to heat exchange Side/rear Fig. Electrical lead Control panel Fig. 448 Programmer selector Fig. Electronic programmer stage indicator Fig. 440D “Empty condensed-water container” indicator Fig. 4/ “Clean filterer” indicator Fig. 4459 Acoustic “programmer end” signal Fig.
How to save energy The LAVA THERM 743 U is a very economical dryer — even more 5o when you follow the hints below: W Spin the laundry in a washing machine with high water extraction (e. g.. at least 800 rpm). W The room in which the dryer is sited should be wall ventilated and the temperature should not exceed 35 C during driving o ensure economical drying. ™ The dryer works most economically with the load sizes as recommended on page 1.
Do’s and don'ts to get the best results dry woolens or wool mixtures in a tumble dryer {isk of fermenting. LEERS oy canticles which carry the symbol JR{on the care label, they are not ‘suitable for machine drying. dry laundry which has not been spun in a washing machine.
How to use your Lava therm Operating and indicator selector Programmer selector Fig, 4/3) The programmer selector controls 3 functions: &) To switch the appliance on and off, indicated by the on/aft of the pilot light. b} To chaise the drying programmer required (sse programmer chart page 1. Programmer selector must be turned clockwise ably. ¢} To switch the fight in the drum on and off . Door release button Fig. 4/ Crass this button to open the loading door. Start button Fig.
How to use your Lava therm Electronic programmer stage indicator Fig. 4/3) The dryer features an electronic programmer stage indicator for programmed the laundry reaches a certain degrees of dryness the relevant symbol lights up. Cn compilation of the drying program ma the end-of-programmer. symbol —md also lights up.
How to use your Lava therm Cleaning the fluff filter Outfit which adheres to the laundry during line drying s removed from the clothes during tumble drying and collects in the fluff inter. The fluff filter has to be cleaned after each drying programmer. The fluffiness s located on the inside of the goading door. Lift up the filter id {see Fig. and remove the fluff from the fitter. Emptying the condensed-water container Empty the condensed-water container (Fig, A£19) after sate drying programmer.
Machine transport and maintenance The heat exchange should be cleaned after approximately 100 drying programmed (approximately every B month. To clean the heat exchange remove it from the machine as follows: 1. Open access flap to heat exchange (fig 1K)} by turning the lever on the fiat to the theft — flap springs open. 2. Unlock heat exchange by turning the two locking discs fig. 5413} & quarter tum in the direction of the arrows. 3.
f you think your machine is not working properly ...if the appliance i not working: MW Have you pressed the start button? B Have you selected a programmer? W Have you closed the loading door? B Haste plug been inserted into the socket? ® Is the fuse in working order? B Has the condensed-water container been emptied and inserted correctly? W Has the overflow protector been activated {see page 12)? «..
Optional extras Thai following items can be obtained as optional extras through your AEG stockist, W The dryer can be adapted to drain the condensed water into an existing drain, sink, stc. o do this you require kit: TRZ 955 ~ ENo. 607839955, Installation W The machine must be installed on a firm and horizontal base.
Electrical connection Please note! (For users in the UK) Warning! All appliances with a 3 core lead must be earthed Please ensure that the voltage and current indicated on the rating plate agrees with the voltage of your electricity supply. 220/240 volts — {i. ., 220240V AG) Your appliance has been equipped with a mains deaf with a molded-on type plug. You must comply with the following refutations: The plug molded on 1o the cord incorporates a fuse. For replacement, use 2 13 amp BS 1362 fuse.