Contents Page Installation Instructions Installation Connection to drainage system . ‘Washer-dryer column Locking and unfrocking of fascia Building-under Size of appliance . Change-over of door hinges Electrical connection { sting Instructions Load capacity .. Wash weights .. What not to put into the dryer Preparation for drying Opening and closing appliance door Controls and Programmed Programmer selection . Starting the programmer . Crease prevention After-drying Reduction of drying temperature ..
@ Installation ‘This dryer can be put into use without the need of any special expenditure or particular installation preparations, The advice which folios should be noted, and any pertinent Regulations of the io~ cal electricity authority should be observed, when making the installation and connection. Conduit your dealer on any technical problems. The dryer can be stood on any even orifice. It must stand level use a spirit revel when checking it.
Washer-dryer column The dryer can be fitted onto any Frontage-loading automatic washing machines, 1o make a washer-dryer combination. The required connecting kit TRZ 917, with fitting instructions, can be abstained through your retailer. Locking and unlocking of fascia _n Built-Under models with flat fascia) Fig. @ When the door opening button is pressed, the section of the fascia which has the programmed sifted on [t} (fig.
@ Change-over of door hinges As supplied, the appliances has the door hinges at the right side. They can be moved to the other side, as follows: ® Lay appliance on is rear side. ® Unscrew and remove the screw {9 mm head width} at the right lower edge of the door. Press the door opening button [t (fig. 3/7), pull the lower edge of the door outwards and lower the door out of the upper hinge bracket.
Operation Instructions Load capacity Cottons max. 5.0 kg Easy-care max. 1.5 kg Wash weights Article: Weight in g, approx. iy cloth robe 1200 Alt cover 700 Bed sheet 500 Blouse 100 Lady's overall 300 Lady's nightdress 200 Briefs 100 Terry cloth towel 200 Tea towel 100 Man's overall 800 Man'’s shirt 200 Man's pajamas 500 T-shirt 100 Underpants, short 100 Underpants, long 250 Pillow case 200 Napkin 100 Handkerchief 20 Table cloth 250 Some of these articles are made of cotton.
Controls and Programmed Which Programmer to use for which type of wash B Cupboard dry v Type of wash: cottons-e. g. knitted articles, toweling, tea towels, pajamas. Load weight: dry weight. Type of wash: easy-care-e. . bedclothes that need no ironing. Load weight: dry weight. A A Iron dry Type of wash: mixtures of cotton or linen that need bed & table linen. Load weight: dry weight, A 6 6 Machine-iron dry Type of wash: mixtures of cotton or linen and starched articles that need ironing or mangling.
Explanations to fig. 3a + 3b Fig. @a: Free-standing model with plastic fascia Fig. @b: Built-under model with fiat fascia 1 Programmer selection nonfood programmer sequence indicator 2 Programmer selection/Set drying revel 3 Condensed water container ~ employing indicator 4 Clean lint filter Selecting the programmer Fig. @ With the programmer selector knob the desired level of dryness should be set {fig. 3/2). Set the desired symbol for a normal [oad in the center position (see Illustration.
After-drying if individual articles in a wash load need to be dried further — e.g. cupboard ready when the load was dried only iron ready ~ these articles can be left in the dryer when the programmer has ended and the moisture control set to # -+ or. The programmer is then restarted with the programmer knob. After-drying time for %% approx. 25 mind. Cooling down phase approx. 15 mind. After-drying time for ¢ approx. 12 mind. Cooling down phase approx. 8 mind.
@B Programmer end/ switching off To switch off when a programmer has finished, tum the programmer knob {fig. 311} clockwise to the 0-position. Thee appliance will now be off and the wash can be removed. Lint indicator Fig. @ If the symbol ® (fig. 2/4) lights up during a programmer, the sequencing is disturbed and the heater is automatically switched off, temporarily, The built-in safety thermostat is protecting the washing against overheating. {illumination of this symbol can be due to: 1.
@ Condensed water container Appliance with plastic face Fig. ® Appliance with flat fascia Fig. if the dryer is not connected directly to a water drainage system, it is necessary to empty the water container after every programmer. Failure to empty the container will cause trouble in the following programmer. When the door is opened, the programmer fascia opens also; pull out the water container, open the cap A and pour out the water.
@8 Shrinking of washing Knitted fabrics in particular depending upon their quality tend to shrink. This is mainly due 1o the fact that, in the dryer, they are dried “floating”, without tension, as compared to drying on the line. Such articles should be dried using the normal or — settling of the moisture control. By pulling and wearing these articles, this sort of shrinkage can largely ~ be reserved. However, we recommend that new garments of these materials be bought in forger sizes. Care Fig.
® breakdown ~ what to do rood quality and modern techniques ensure that your appliance functions well. f a fault should occur, please check whether all hints and advice contained n these Instructions have been flowed. It is possible that only & minor alt is the reason for the breakdown, { you cannot find any appropriate hint n these instructions, our well organized Customer Service is at your disposal. The Customer Service locations are applied separately.