Contents Safety instructions Before first use For the user You should also note the following Out of concern for the [important recommendations for drying Machine description Before drying correct drying Loading your laundry Opening the loading door Loading your laundry Removing and putting back laundry Selecting the drying programmer Programmer selector switch illuminated indicator for degrees of dryness and programmer end The buttons and their functions Programmer tables Cooling-phase and antic crease pro
Before first USE Safety instructions for the user Safety instructions | must be installed level. My four adjustable feet can be used o compensate for uneven flora conditions. Please use a screwdriver to adjust my adjustable feet. Place the screwdriver in the vertical slots visible from the front.
TUBA 1200 GB SWAY 1200 8B ~ If any other maintenance needs to be cared out, you are also ' i basically recommended to contact our service center or @ repair shop authorized by ourselves. Only original AEG spare parts fulfill alf requirements! if 1 am installed under a worktop in your kitchen or utility room, an earthed intermediate panel must be provided as process protection according to the installation and connection instructions when the worktop has been removed.
~ Articles containing foam rubber or similar materials must also not be machine-dried. The dryer may catch fire. + Fabrics containing residues of hair spray, nail varnish remover, hair setting notion, or similar agents should not be machine-dried owing to the danger of gas formation. ~ i so-called “conditioners” are machine-dried regardless of the respective properties of these conditioners — coating of the fluff fighter sufficient to cause choking cannot be excluded.
2U5TA 1200 B Out of concern for the environment All tumble dryers require energy for drying. | am especially economical to run if you take note of the following hints: B Thoroughly spin-dry your laundry first! 1 am especially energy-saving to run if your laundry is well spin dried before tumble-drying . . at least at 800 min™), Higher spin speeds reduce consumption, shorten the drying time, and make drying tore economical.
Woolens and downs Care symbols Gentle programmer/ S-button Creasing Knitwear Starched foundry " Important recommendations on drying Never dry wool or wool mixtures (felting risk). Down-filled fabrics should also not be dried in me, since, depending on quality, the fine interns fibers tend to shrink. Linen fabrics may be dried only if you find a manufacturer’s instruction to that effect. The caloric: may “roughen” if | am improperly used for tumble-drying.
TEMPE 12000 OB Spin-dry your laundry well before tumble-drying {at least at 800 min'Y). Higher spin speeds reduce power consumption during drying and make it more economical. Easy-care fabrics should be briefly spun before they are loaded in my drum, Close zip-fasteners and tie together loose strings (e. g. of sprang. You will thereby avid tangoing of your laundry. Clothes made of double-layered fabrics {poly amide outer layer, cation inner layer, 8. g. anoraks) should be muted inside out before drying.
Features Machine description oy 2050 Saks B A s cot lbs A Programmer selector switch B fulminated indicator for degrees of dryness and programmer end € Operating indicator © Illuminated indicator for fluff fitter £ Signal button for programmer end F Gentle bun;m G Start button H Door release and cancel button for all selected additional functions ALEJANDRO 12790 BB
DISSOLUBLE 180 GB 2015 A Detachable worktop B Machine door.
Sorting your laundry Take care when handling some fabrics Before drying When the programmer has ended 10 Before drying Sort your laundry according to Cottons and linen ~ Easy-care laundry ~, Dark-colored laundrywoman ~ Light-colored laundry/fabrics Make sure that your laundry is suitable for machine-drying. Never dry wool or wool mixtures or knitwear made of or containing wool felting risk). Empty pockets. Remove metal abject g. paper clips, safety ping, etc.).
RS 1200 GB Loading your laundry Yau have two ways of opening rmy loading door: 1. Press the door release button 2 To open ry door in this way, you must connect me to the mains supply. That means, you must place the power plug in the plug socket and tum my programmer selector switch from the 0 position, in this case, my operating indicator lights up. 2. Door trip function If you have not connected me to the mains supply §. €.
Programmer selector switch Ruminated indicator for degrees af dryness . o programmer end 12 Selecting the drying programmer o433 You can tum my programmer selector switch both to the right and left from any position, It has three functions: Using the programmer selector switch, you switch me on and off Depending on the operational status, ry operating indicator then comes on or goes out — Via the programmer selector switch, you select your drying programmer.
mat 200 68 The symbols have the following meanings: OOO Wringer-dry } not indicated on programmed OO nor-chry 8~8 O Slightly dry Storage-dry Extra-dry Programmer end The meaning of the individual symbols are also given in the programmer Survey on my front wall, 13
Tha hut ion constrictions Clear/cancel and door release button 14 Combination of the main and additional programmed with my buttons gives a range of programmed meeting all requirements. OOH When bunions are pressed, & red mark appears in the display located above. 2/25 To enable this button to fulfill its function, you must connect me to the mains supply and turn my programmer selector switch from the O position.
EAG (/00 OB BARRIO 1290 GE YBA THIGHS B BAIZE 1280 OB You start the pres elected programmer with this button. My heating capacity is reduced when you press this button. This Button enables you {0 dry temperature-sensitive foundry, such as &. g. acrylics or fabrics marked on the care label. The drying times are correspondingly prolonged by the lower heating capacity. Please also note that economical use of the S-buttons only assured at low wash loads {1 — 2 kg).
Laundrywoman Gentle Consumption Time duration examples button use | valuesinkWh® | in min Terry lowering, o bathrobes Terry toweling, cotton jersey na 3.2 75 laundry, flannelette bedding, entry kitchen towels Cotton horsey laundry, o cotton shirts Bedding, e 25 80 tablecloths Bedding, no tablecloths “Values refer to 5.
Switching off the machine 18 Cooling phase and anti-crease sequence Shortly before the programmer end, my heating system is switched off 10 cool your foundry. Unless you immediately remove your laundry from my drum when the drying sequence has ended, the minute anti-crease programmer automatically follows. During this sequence the alternately reversing tumbling action of the drum continuously Loosens the foundry so that reaming fluffy and crease-reg until taken out.
GABFEST 1290 GB Indication of operating faults In many cases, only minor operating faults cause an appliance not to aerate properly. To spare you the need to call the service center whenever operating faults scour, my degree of dryness indicator and the illuminated indicators alert you to the following faults, which you can correct yourself: 1. The programmer end indicator briefly fights up after starting on programmed 1 -8 without simultaneous indication of the degree of dryness.
Cleaning the inside of the drum Loaning the controls 20 Cleaning the fluff filter Abraded fabric ~ 70% generated during wearing, 20% during washing, and only 10% during drying {source: HEA, Hauptberatungsstefle fir Elektrizitatsanwendung e. V. Frankfurt {electricity use advice center} — arises in the form of fluff and collects in the fluff fighter inside the machine door. To ensure trouble-free air circulation, you must clean my fluff filter after every drying sequence.
PANTALOON DIST OB — MISBEHAVE 1230 B 1f you think your tumble dryer is not working properly i the dryer does not work? Have you plugged in the machine? Have you set the programmer selector switch? Have you pressed the start button? Have you closed the door properly? Is the fuse in the fuse box in goad working order? if the machine does not dry satisfactorily? Have you set the correct program? Has the degree of dryness indicator indicated an operating fault? Have you cleaned the fluff filter? Have you used t
22 Customer service i you find no reference to any particular fault in my Operating instructions, please contact the service center. When doing so, quote the E-No, and F-No. of your dryer. You will find these numbers on rry rating plate.
2/toat0am GB Technical data Dimensions: With worktop: Height 850om Width 80.0cm Depth 60.0cm Without worktop: Height 82.0cm Width $85cm Depth §7.0cm Conn action: You will find information on electrical connection on the rating plate of your machine.