EN User Manual Washer Dryer L75670WD
www.aeg.com CONTENTS 1. SAFETY INFORMATION.................................................................................................3 2. SAFETY INSTRUCTIONS................................................................................................ 5 3. PRODUCT DESCRIPTION.............................................................................................. 7 4. CONTROL PANEL...........................................................................................................8 5.
ENGLISH 1. 3 SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. Always keep the instructions with the appliance for future reference. 1.1 Children and vulnerable people safety WARNING! Risk of suffocation, injury or permanent disability.
www.aeg.com • • • • • • • • • • • • • side, where the appliance door can not be fully opened. Connect the mains plug to the mains socket only at the end of the installation. Make sure that there is access to the mains plug after the installation. The ventilation openings in the base (if applicable) must not be obstructed by a carpet. Ensure you have good ventilation in the installation room to avoid the back flow of gases into the room from appliances burning other fuels, including open fires.
ENGLISH • • • • • • • 5 or pillows fitted with foam rubber pads should not be dried in the wash dryer. Fabric softeners, or similar products, should be used as specified by the fabric softener instructions. Remove all objects from pockets such as lighters and matches. Never stop the wash dryer before the end of the drying cycle unless all items are quickly removed and spread out so that the heat is dissipated.
www.aeg.com • Always use a correctly installed shockproof socket. • Do not use multi-plug adapters and extension cables. • Do not pull the mains cable to disconnect the appliance. Always pull the mains plug. • Do not touch the mains cable or the mains plug with wet hands. • Only for UK and Ireland: The appliance has a 13 amp mains plug. If it is necessary to change the fuse in the mains plug, use a 13 amp ASTA (BS 1362) fuse. • This appliance complies with the E.E.C. Directives. 2.
ENGLISH 7 3. PRODUCT DESCRIPTION 3.1 Appliance overview 1 2 3 4 5 1 2 3 4 5 6 7 Worktop Detergent dispenser Control panel Door handle Rating plate Drain pump filter Feet for the appliance level 6 7 3.2 How to activate the child safety device To close the door, turn the device anticlockwise until the groove is vertical. This device prevents children or pets to be closed in the drum. 3.3 Fixing plate kit (4055171146) Turn the device clockwise, until the groove is horizontal.
www.aeg.com 4. CONTROL PANEL 4.1 Control panel description 1 2 3 10 1 2 3 4 5 6 7 On/Off button (On/Off) Programme knob Display Start Pause button (Inicio/Pausa) Delay start button (Inicio Diferido) Time save button (Extra Rapido) Drying time button (Tiempo/Tempo de sec.) 9 8 7 6 5 4 8 Automatic drying button (Nivel de sec.) 9 Spin reduction button (Centrif.) 10 Temperature button (Temp.) 4.2 Display A B Temperature area: A Temperature indicator Cold water indicator.
ENGLISH Spin area: Spin speed indicator B No Spin indicator1) Rinse Hold indicator 1) Only available for Spin/Drain programme. Dryness level symbols1): Iron dry Cupboard dry Extra dry Display indicators2): C Door locked - You cannot open the door when this symbol is on. You can open the door only when the symbol goes off. Washing phase Drying phase Child safety lock Extra rinse Delay start 1) They come on when you set an automatic drying programme.
www.aeg.com Time area: Programme duration (washing and/or drying phase) When the programme starts, the time decreases with steps of 1 minute. Delay start When you press the delay start button, the display shows the delay start time. D Alarm codes If the appliance has a malfunction, the display shows alarm codes. Refer to 'Troubleshooting' chapter. Message of error The display shows this message for some seconds when: • You cannot set a function with the washing programme.
ENGLISH Programme Temperature range Delicados 40°C - Cold Lana/Lãs 40°C - Cold 20 Min.-3 Kg 40°C - 30°C Aclarado/Enxaguar Centrif./Drenar3) 11 Maximum load Maximum spin speed Programme description (Type of load and soil level) 3.5 kg 1200 rpm Delicate fabrics as acrylics, viscose, polyester items. Normal soil. 1.5 kg 1200 rpm Machine washable wool, hand washable wool and delicate fabrics with «hand washing» care symbol.
www.aeg.com Programme Temperature range Algod. Eco5) 60°C - 40°C Maximum load Maximum spin speed Programme description (Type of load and soil level) 7 kg 1600 rpm White cotton and colour-fast cotton. Normal soil. The energy consumption decreases and the time of the washing programme is extended. 1) To reduce the creases of the laundry, this cycle regulates the water temperature and performs a soft wash and spin phase. The appliance adds some rinses. This programme is not compatible with drying.
ENGLISH 13 6.
www.aeg.com 8. WOOLMARK CERTIFICATE • The wool wash cycle of this machine has been approved by The Woolmark Company for the washing of wool garments labelled as «hand wash» provided that the garments are washed according to the instructions issued by the manufacturer of this washing machine. Follow the garment care label for drying and other laundry instructions.
ENGLISH Programmes Load (kg) Wool/Handwash 30 °C 15 Energy Water conApproximate proconsump- sumption (li- gramme duration tion (kWh) tre) (minutes) 1.5 0.30 45 68 1) «Cotton Energy Saving programme » at 60°C with a load of 7 kg is the reference programme for the data entered in the energy label, in compliance with EEC 92/75 standards. 10. OPTIONS 10.1 Temp. the appliance. The display shows the symbol of the set level: Set this option to change the default temperature. Indicator = cold water.
www.aeg.com 10.6 Inicio Diferido The display shows the related indicator. With this option you can delay the start of a programme from 30 minutes to 20 hours. 11. SETTINGS 11.1 Acoustic signals The acoustic signals operate when: • You activate the appliance. • You deactivate the appliance. • You press the buttons. • The programme is completed. • The appliance has a malfunction. To deactivate/activate the acoustic signals, press Nivel de sec. and Tiempo/ Tempo de sec. at the same time for 6 seconds.
ENGLISH 17 CAUTION! Make sure that no laundry stays between the seal and the door. There is a risk of water leakage or damage to the laundry. 13.2 Filling the detergent and additives 3. To use powder detergent, turn the flap up. A Compartment for prewash phase, soak programme or stain remover. Compartment for washing phase. Compartment for liquid additives (fabric conditioner, starch). Maximum level for quantity of liquid additives. Flap for powder or liquid detergent. 4.
www.aeg.com With the flap in the position DOWN: • Do not use gelatinous or thick liquid detergents. • Do not put more liquid detergent than the limit showed in the flap. • Do not set the prewash phase. • Do not set the delay start function. 5. Measure out the detergent and the fabric conditioner. 6. Carefully close the detergent dispenser. Make sure that the flap does not cause a blockage when you close the drawer. 13.4 Activating the appliance 1. Open the water tap. 2.
ENGLISH 13.9 Cancelling the delay start To cancel the delay start: 1. Press button Inicio/Pausa to set the appliance to pause. The related indicator flashes. 2. Press button Inicio Diferido repeatedly until the display shows . 3. Press button Inicio/Pausa again to start the programme immediately. 13.10 Interrupting a programme and changing a function You can change only some options before they operate. 1. Press button Inicio/Pausa. The related indicator flashes. 2. Change the function set. 3.
www.aeg.com The appliance drains the water and spins. 3. When the programme is completed and the door lock indicator goes off, you can open the door . 4. Press On/Off some seconds to deactivate the appliance. The appliance drains and spins automatically after approximately18 hours. 13.15 AUTO Stand-by option • You do not use the appliance for 5 minutes before you press Inicio/Pausa button. Press the button On/Off to activate the appliance again.
ENGLISH 14.3 Timed Drying The laundry can also be dried with a manual timed drying: 1. Press Tiempo/Tempo de sec. again and again to set the time value (see the «Programmes for timed drying» table). • The display shows the set time . Each time you value: e.g. press this button the time value increases by 5 minutes. • After some seconds the display . shows a new time value: e.g. The appliance calculates also the duration of the anti-crease and the cooling phases. 2.
www.aeg.com 15.2 Washing & Automatic drying 1. Press Nivel de sec. again and again until the display shows one of the dryness level indicator: • : IRON DRY level indicator for cotton items • : CUPBOARD DRY level indicator for cotton and synthetic items • : EXTRA DRY level indicator for cotton items The display shows the indicator . The time value on the display is the duration of the washing + drying cycles, calculated on a default load size.
ENGLISH 15.6 How to remove the fluff in the garments To remove the fluff inside the drum, set a special programme: 23 the cleaning function until the display shows CLE. 5. Press Inicio/Pausa to start the programme. 1. Empty the drum. 2. Clean the drum, the gasket and the door with a wet cloth. 3. Set the rinse programme. 4. Press at the same time Centrif. and Tiempo/Tempo de sec. to activate 16. HINTS AND TIPS WARNING! Refer to Safety chapters. 16.
www.aeg.com 16.4 Ecological hints • Set a programme without the prewash phase to wash laundry with normal soil. • Always start a washing programme with the maximum load of laundry. • If necessary, use a stain remover when you set a programme with a low temperature. • To use the correct quantity of the detergent, check the water hardness of your domestic system 16.5 Water hardness If the water hardness in your area is high or moderate, we recommend that you use a water softener for washing machines.
ENGLISH 25 17. CARE AND CLEANING 17.3 Maintenance wash WARNING! Refer to Safety chapters. With the low temperature programmes it is possible that some detergent stays in the drum. Make regularly a maintenance wash. To do this: 17.1 External cleaning Clean the appliance only with soap and warm water. Fully dry all the surfaces. • Remove the laundry from the drum. • Set the cotton programme with the highest temperature with a small quantity of detergent.
www.aeg.com 3. 4. 17.6 Cleaning the inlet hose and the valve filter 1. 2. 1 2 3 3. 4. 45° 20° 17.7 Cleaning the drain filter WARNING! Do not clean the drain filter if the water in the appliance is hot.
ENGLISH 1. 2. 1 1 2 3. 4. 2 1 5. 6. 1 7. 2 8.
www.aeg.com 9. 17.8 Emergency drain Because of a malfunction, the appliance cannot drain the water. If this occurs, do steps (1) through (9) of 'Cleaning the drain filter'. If necessary, clean the pump. When you drain the water with the emergency drain procedure, you must activate again the drain system: 1. When you drain the water with the emergency drain procedure, you must activate again the drain system: Put 2 litres of water in the main wash compartment of the detergent dispenser. 2.
ENGLISH • - The anti-flood device is on. Disconnect the appliance and close the water tap. Contact the Authorised Service Centre. 29 WARNING! Deactivate the appliance before you do the checks. 18.2 Possible failures Problem Possible solution The programme does not start. Make sure that the mains plug is connected to the mains socket. Make sure that the appliance door is closed. Make sure that there is not a damaged fuse in the fuse box. Make sure that the Start/Pause has been pressed.
www.aeg.com Problem Possible solution The spin phase does not operate or the washing cycle lasts longer than usually. Set the spin programme. Make sure that the drain filter is not clogged. Clean the filter, if necessary. Refer to 'Care and cleaning'. Adjust manually the items in the tub and start the spin phase again. This problem may be caused by balance problems. There is water on the floor. Make sure that the couplings of the water hoses are tight and there is not water leakages.
ENGLISH Problem Possible solution You cannot set an option. Make sure that you press only the wanted touch button(s). The appliance does not dry or does not dry correctly. Turn the water tap on. 31 Make sure the drain filter is not clogged. Reduce the laundry load. Make sure you have set the correct cycle. if necessary ,set again a short drying time. The laundry is full of different colours fluff.
www.aeg.com 5. Take out the laundry and then close the appliance door. 6. Close the filter flap. 19.
ENGLISH 33
www.aeg.
ENGLISH 35
132910821-A-142014 www.aeg.