L 75260 TL1 EN User manual
www.aeg.com CONTENTS 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. SAFETY INFORMATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 SAFETY INSTRUCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 PRODUCT DESCRIPTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 ACCESSORIES . . . . . . . . . . . . . . . . . . . . . .
ENGLISH 3 1. SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. Always keep the instructions with the appliance for future reference. 1.1 Children and vulnerable people safety WARNING! Risk of suffocation, injury or permanent disability.
www.aeg.com • If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. • The operating water pressure (minimum and maximum) must be between 0,5 bar (0,05 MPa) and 8 bar (0,8 MPa) • The ventilation openings in the base (if applicable) must not be obstructed by a carpet. • The appliance is to be connected to the water mains using the new supplied hose-sets. Old hose sets must not be reused. 2.
ENGLISH ance. Contact the Service to ensure which accessories can be used. Water connection • Make sure not to cause damage to the water hoses. • The appliance is to be connected to the water mains using the new supplied hose-sets. Old hose sets must not be reused. • Before you connect the appliance to new pipes or pipes not used for a long time, let the water flow until it is clean. • The first time you use the appliance, make sure that there is no leakage. 2.
www.aeg.com 3. PRODUCT DESCRIPTION 1 7 2 8 3 9 10 6 4 5 6 11 1 Control panel 7 Mains cable 2 Lid 8 Water inlet valve 3 Lid button 4 Filter access door 9 Water drain hose 10 Transit bolts 5 Lever to move the appliance 11 Feet for the appliance level 6 Adjustable feet 4. ACCESSORIES 1 2 3 1 Plastic cap To close the hole on the rear side of the cabinet, after the removal of the transit bolt. 2 Plastic hose guide To connect the drain hose on the edge of a sink.
ENGLISH 7 5. CONTROL PANEL 1 2 3 10 1 On/Off button 2 Programme knob 3 Display 4 5 6 Start/Pause button Delay start button Time saving button 7 Liquid detergent button 8 9 10 Stain button Spin button Temperature button 5.1 On Off button 1 9 8 7 6 5 4 The AUTO Stand-by function automatically deactivates the appliance to decrease the energy consumption when: • You do not use the appliance for 5 minutes before you press button 4 . – All settings are cancelled.
www.aeg.com B • The default spin speed of the programme. • 'No Spin'1) and 'Rinse Hold' symbols. C • The display symbols.2) Symbols Description Washing phase Rinse phases Spin phase Child lock Extra rinse You cannot open the appliance door when the symbol is on. You can open the door only when the symbol goes off. If the programme is completed but the symbol stays on: • There is water in the drum. • The 'Rinse Hold' function is on.
ENGLISH 5.6 Time save button 6 5.10 Temperature button 10 Press the button 6 to decrease the programme duration. • Press one time to set 'Shortened duration' for items with daily soil. • Press two times to set 'Extra Quick' for items with almost no soil. Press button 10 to change the default temperature. Some programmes accept only one of the two functions. 5.7 Liquid detergent button 7 Press button 7 to adapt the cycle if you use a liquid detergent. 5.
www.aeg.com 6. WASHING PROGRAMMES Programme Temperature Type of load Cycle max. weight of load description Functions Cottons 95° - Cold White and coloured cotton with normal soil. max. 6 kg Wash Rinses Long spin SPIN REDUCTION RINSE HOLD STAIN1) LIQUID DETERGENT EXTRA RINSE TIME SAVE2) White and coloured cotton with heavy soil. max.
ENGLISH Programme Temperature Type of load Cycle max. weight of load description Functions Delicates 40° - Cold Delicate fabrics as Wash acrylics, viscose, pol- Rinses yester items with nor- Short spin mal soil. max. 3 kg SPIN REDUCTION RINSE HOLD STAIN1) LIQUID DETERGENT EXTRA RINSE TIME SAVE2) Machine washable Wash wool. Hand washable Rinses wool and delicate Short spin fabrics with «hand washing» care symbol. max.
www.aeg.com Programme Temperature Type of load Cycle max. weight of load description Functions ECO Economy7) 60° - 40° White and fast coloured cotton with normal soil. max. 6 kg SPIN REDUCTION RINSE HOLD STAIN LIQUID DETERGENT EXTRA RINSE TIME SAVE2) Wash Rinses Long spin 1) The STAIN function is not available with a temperature lower than 40°C. 2) if you press the button 6 two times (Extra Quick duration), we recommend that you decrease the quantity of the load.
ENGLISH Programme1) Type of load 13 Max. load Steam can be used for dried, washed or worn once laundry. These programmes can reduce creases and odours and make your laundry more smooth. Do not use any detergent. If necessary, remove stains by washing or using localized stain removal. Steam programmes do not perform any hygienic cycle. 1) If you set a Steam programme with dried laundry, at the end of the cycle the laundry feels humid.
www.aeg.com Programmes Load (Kg) Energy con- Water consumption sumption (li(kWh) tre) Approximate programme duration (minutes) Remaining moisture (%)1) Standard 60 °C cotton 6 0.83 44 182 53 Standard 60 °C cotton 3 0.55 33 145 53 Standard 40 °C cotton 3 0.42 33 129 53 1) At the end of spin phase. Off Mode (W) Left On Mode (W) 0.48 0.48 The information given in the charts above are in compliance with the EU Commission regulation 1015/2010 implementing directive 2009/125/EC.
ENGLISH 4. Close the drum and the lid of your washing machine. 15 Before you close the lid of your appliance, make sure that you close the drum correctly. 9.2 Using detergent and additives • Measure out the detergent and the fabric conditioner. Detergent compartment for prewash phase. The marks MAX are the maximum levels for the quantity of detergent (powder or liquid). Detergent compartment for washing phase. The marks MAX are the maximum levels for the quantity of detergent (powder or liquid).
www.aeg.com 3. 4. CLICK B • Position A for powder detergent (factory setting). • Position B for liquid detergent. When you use the liquid detergent: – Do not use gelatinous or thick liquid detergents. – Do not put more liquid then the maximum level. 9.3 Setting and starting a programme 9.5 Cancel a programme 1. Press button 1 to cancel the programme and to deactivate the appliance. The indicator of button 4 flashes with red colour. 3. The display shows the default temperature and spin speed.
ENGLISH Before you press button 4 to start the appliance, you can cancel or change the set of the delay start. You cannot set the delay start with the Steam programme. 9.8 Cancel the delay start 1. Press button 4 . The related indicator flashes. 2. Press button 5 again and again until the display shows 0’. 3. Press button 4 . The programme starts. 9.9 Open the lid While a programme or the delay start operates, the lid is locked. To open the lid: 1. Press button 4 .
www.aeg.com 10. HELPFUL HINTS AND TIPS 10.1 The laundry load • Divide the laundry in: white, coloured, synthetics, delicates and wool. • Obey the washing instructions that are on the laundry care labels. • Do not wash together white and coloured items. • Some coloured items can discolour with the first wash. We recommend that you wash them separately for the first times. • Button up pillowcases, close zippers, hooks and poppers. Tie up belts. • Empty the pockets and unfold the items.
ENGLISH 19 Water hardness table Level Type Water hardness °dH °T.H. mmol/l Clarke 1 soft 0-7 0-15 0-1.5 0-9 2 medium 8-14 16-25 1.6-2.5 10-16 3 hard 15-21 26-37 2.6-3.7 17-25 4 very hard > 21 > 37 >3.7 >25 11. CARE AND CLEANING WARNING! Disconnect the appliance from the mains supply before you clean it. 11.1 Descaling The water we use contains limescale. If it becomes necessary, use a water softener to remove limescales. Use a special product made for washing machines.
www.aeg.com WARNING! • Disconnect the mains plug from the mains socket. • Do not remove the filter while the appliance operates. Do not clean the drain filter if the water in the appliance is hot. The water must be cold before you clean the drain filter. 11.5 Drain filter Regularly examine the drain filter and make sure that it is clean. To clean the drain filter: 1. Open the drain filter door. 2. Put a container below the recess of the drain filter to collect the water that flows out.
ENGLISH 4. 5. 6. 7. 21 Remove the inlet hose behind the appliance. Clean the filter in the valve with a stiff brush or a towel. Install again the inlet hose. Make sure that the couplings are tight to prevent leakages. Open the water tap. 90˚ 11.7 Emergency drain Because of a malfunction, the appliance cannot drain the water. If this occurs, do steps (1) through (3) of 'To clean the drain filter'. If necessary, clean the filter. Put the drainage duct back and close the drain filter flap. 11.
www.aeg.com With some problems, the acoustic signals operate and the display shows an alarm code: • - The appliance does not fill with water. • - The appliance does not drain the water. • - The appliance door is open or not closed correctly. • - The anti-flood device is on. WARNING! Deactivate the appliance before you do the checks. Problem Possible cause Possible solution The appliance does not fill with water. The water tap is closed. Open the water tap. The water inlet hose is damaged.
ENGLISH Problem The programme does not start. There is water on the floor. 23 Possible cause Possible solution The filter of the drain pump is blocked. Clean the filter of the drain pump. Refer to 'Care and cleaning'. Balance problems with the laundry load. Adjust manually the items in the tub and start the spin phase again. The mains plug is not connected in the mains socket. Put in the mains plug. Blow out fuse in the household fuse box. Replace the fuse. You did not press button 4 .
www.aeg.com Problem Possible cause Possible solution You did not remove the stubborn stains before you wash the laundry. Use special products to remove the stubborn stains. Incorrect temperature was set. Make sure that you set the correct temperature. Too much laundry load. Decrease the laundry load. After the check, activate the appliance. The programme continues from the point of interruption. If the problem occurs again, contact the service centre.
ENGLISH 25
www.aeg.
ENGLISH 27
108806300-A-462012 www.aeg.