ARCTIS 1333-6 i Integrating Freezer Operating and Installation Instructions
Dear customer, Before placing your new refrigerator/freezer into operation please read these operating instructions carefully. They contain important information for safe use, for installation and for care of the appliance. Please keep these operating instructions for future reference. Pass them on to possible new owners of the appliance.
Contents Safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Disposal . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Appliance Packaging Information . . . . . . . . . . . . . . . . . . . . . . . 5 Disposal of old Appliances . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Remove transport packaging . . . . . . . . . . . . . . . . . . . . . . . . . 6 Starting up and temperature regulation . . . . . . . . . . . . . . . .
Safety Please read this instruction book before using the appliance and retain for future reference. These warnings are provided in the interests of your safety, ensure you understand them fully before using the appliance. Intended use ¥ The appliance is intended for use in the home. It is suitable for the freezing and storing of frozen food, as well as for making ice.
cartridges etc in the refrigerator/freezer. ¥ Bottles and cans must not be placed in the freezer compartment. They can burst when the contents freeze, high carbonate content drinks can even explode! Never store lemonade, juices, beer, wine, sparkling wine etc. in the freezer compartment. ¥ Ice cream or ice cubes can cause Òfrost/freezerÓ burns if consumed straight from the freezer. ¥ Do not touch frozen food with wet hands. Your hands could stick to the food.
Warning! Before disposing of old appliances make them inoperable. Remove plug from mains, sever the power cable, remove or destroy any snap or latch closures, to prevent small children being trapped inside. ¥ Contact your local Council or Environmental Health Office to see if there are facilities in your area to recycle the appliance. Remove transport packaging The appliance and the interior fittings are protected for transport.
Operating and indicator panel A A Fast feezing push button B Fast feezing light (yellow) C Alarm light (red) D Operating light (green) E ON/OFF push button F Temperature control knob B C D E F The green pilot lamp (D), which comes on when the mains voltage is available and the ON/OFF button is pushed. Turn the temperature control knob to a number position, the tempeature will be automatically regulated..
Ð excessive amounts of fresh food are placed inside; or Ð if the appliance door is open for too long. Important note: if you operate the fast-freeze switch or adjust the temperature control knob, the motor might not start immediately but only after some time. This does not mean that your appliance has a fault.
Ice pack There is an ice pack in one drawer of the freezer. In the event of a power failure or malfunction, the ice pack will lengthen the amount of time it takes for the frozen food to become too warm by several hours. The ice pack can only fulfil this task efficiently if it is placed in the uppermost drawer, at the front, above the frozen food. You can use the ice pack for cooling cold bags. Freezing and storing frozen food You can use your freezer for freezing fresh food yourself.
Important! Do not touch frozen food with wet hands. Your hands could stick to the food. 1. 2. 3. Place the packed food in the drawers. Place food to be frozen as shown in figure. Unfrozen food must not touch items already frozen, otherwise the frozen food could begin to defrost. Press the fast freeze button 24 hours before introducing fresh food for freezing of fresh food. The yellow light comes on. 9 Kg 7 Kg D670 Place frozen foods in the drawers sorted by type, as far as possible.
Defrosting The freezer will become progressively covered with frost. This should be removed with the special plastic scraper provided, whenever the thickness of the frost exceeds 4 mm. During this operation it is not necessary to switch off the power supply or to remove the foodstuffs. However when the ice becomes very thick on the inner liner, complete defrosting should be carried out as follows: 1.
Switching off the appliance 1. 2. 3. 4. To switch off the appliance, turn the temperature control knob to position "0" or disconnect from the electricity supply. If the appliance is not going to be used for an extended period: Remove all packages as well as ice trays. Remove the mains plug or switch off. Defrost freezer compartment and clean thoroughly (see section: ÒCleaning and CareÓ). Leave the door open to avoid the build up of odours.
and with a little bicarbonate of soda added (5ml to 0,5 litre of water). 4. Dry the appliance thoroughly. 5. When everything is dry place the appliance back into service. Energy Saving Tips ¥ Do not install the appliance near radiators or other sources of continuous warmth. High ambient temperatures cause longer, more frequent operation of the compressor. ¥ Ensure sufficient air circulation at the appliance base and at the back wall of the appliance. Never cover air vent openings.
Symptom Possible Cause Remedy Appliance is not switched on Switch on the appliance. Mains plug is not plugged in Insert mains plug. or is loose. Appliance does not work. Fuse has blown or is defec- Check fuse, replace if tive. necessary. Socket is defective. Appliance cools too much. Mains malfunctions are to be corrected by an electrician. Temperature is set too cold. Turn the temperature control knob to a warmer setting. Temperature is not properly Please look in the "Initial adjusted.
Service and Spare Parts If you require a service engineer or wish to purchase spare parts, contact your local AEG Service Force Centre by telephoning: 0870 5 929929 Help us to help you Please determine your type of enquiry before telephoning. When you contasct us we need to know: 1.Your name, address and post code 2.Your telephone number 3.Clear and concise details of the fault - What is the fault? - When does the fault occur? 4.The model, production number and product identification number.
Guarantee Conditions Guarantee Conditions AEG offer the following guarantee to the first purchaser of this appliance. 1. The guarantee is valid for 12 months commencing when the appliance is handed over to the first retail purchaser, which must be verified by purchase invoice or similar documentation. The guarantee does not cover commercial use. 2. The guarantee covers all parts or components which fail due to faulty workmanship or faulty materials.
Installation Electrical Connection Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. WARNING Ð THIS APPLIANCE MUST BE EARTHED The manufacturer declines any liability should these safety measures not be observed. Before switching on, make sure the electricity supply voltage is the same as that indicated on the appliance rating plate. The rating plate is inside, on the left. The appliance is supplied with a 13 amp plug fitted.
Installation Location The appliance should be installed up in a well ventilated, dry room. Energy use is affected by the ambient temperature. The appliance should therefore Ð not be exposed to direct sunlight; Ð not be installed next to radiators or other sources of continuous heat; Ð only be installed at a location whose ambient temperature corresponds to the climate classification, for which the appliance is designed.
remove relevant pins at the top and at the bottom. Warning! Disconnect from the electricity supply before reversing the door. Housing dimensions Height Depth Width 880 mm 550 mm 560 mm Instructions for building-in Apply joint the sealing strip as shown in figure. D765 A Push appliance into the housing until stop strip (A) touches the kitchen unit.
Open the door and push the appliance against the side of the kitchen unit opposite to that of appliance hinges. Fasten the appliance with 4 screws provided in the kit included with the appliance. Snap vent grille (C) and hinge cover (D) into position. D C D727 Apply covers (B) into relevant holes.
50mm Place guide (A) on the inside part of the furniture door, in upper and lower positions as shown in the figure and mark the position of the holes. After having drilled holes, fix the guide with the screws supplied. A 20 m m PR166 Fix cover (C) on guide (A) until it clips into place. A C PR33 Open the appliance door and the furniture door at 90¡. Insert the small square (B) into guide (A). Put together the appliance door and the furniture door and mark the holes as indicated in the figure.
At the end of installation/adjusting, it is necessary to check if the door of the furniture closes properly. Should the lining up of the furniture door be necessary, use the clearance of slots. PR168 Fix cover (D) on guide (B) until it clips into place. B D PR167/1 Regulations, Standards, Guidelines This appliance was designed for household use and was manufactured in accordance with the appropriate standards.
AEG HausgerŠte GmbH Postfach 1036 D-90327 NŸrnberg http://www.aeg.hausgeraete.