ARCTIS 1333-6i Integrierbare Einbau Gefrierschrank Integrating Freezer Gebrauchs- und Einbauanweisung Operating and Installation Instructions
Dear customer, Before placing your new refrigerator/freezer into operation please read these operating instructions carefully. They contain important information for safe use, for installation and for care of the appliance. Please keep these operating instructions for future reference. Pass them on to possible new owners of the appliance.
Contents Safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 25 Disposal . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 27 Appliance Packaging Information . . . . . . . . . . . . . . . . . . . . .27 Disposal of old Appliances . . . . . . . . . . . . . . . . . . . . . . . . . .27 Remove transport safeguard . . . . . . . . . . . . . . . . . . . . . . . 27 Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Safety The safety aspects of our refrigerators/freezers comply with accepted technical standards and the German Appliance Safety Law. Nevertheless, we consider it our obligation to make you aware of the following safety information: Intended use ¥ The refrigerator is intended for use in the home. It is suitable for the cooling, freezing and storing of frozen food, as well as for making ice.
mains plug, cut off the mains cable, break or remove spring or boltcatches, if fitted. By doing this you ensure that children cannot lock themselves in the fridge when playing (there is risk of suffocation!)or get themselves into other dangerous situations. ¥ Often children cannot recognise the hazards present in household appliances.
Disposal Appliance Packaging Information All materials are environmentally sound! They can be dumped or burned at an incinerating plant without danger! About the materials: The plastics can be recycled and are identified as follows: >PE< for polyethylene, e.g. the outer covering and the bags in the interior. >PS< for polystyrene foam, e.g. the pads, which are all free of chlorofluorocarbon.
Installation Installation Location The appliance should be set up in a well ventilated, dry room. Energy use is affected by the ambient temperature. The appliance should therefore Ð not be exposed to direct sunlight; Ð not be installed next to radiators, cookers or other sources of heat; Ð only be installed at a location whose ambient temperature corresponds to the climate classification, for which the appliance is designed.
50 mm For safety reasons, minimum ventilationmust be as shown Fig. Attention: keep ventilation openings clear of obstruction; min. 200 cm 2 Your appliance needs air min. cm 200 2 D567 Housing dimensions Height Depth Width 880 mm 550 mm 560 mm Rehingeing the door The side at which the door opens can be changed from the right side (factory adjustment) to the left side, if the installation site requires.
Instructions for total built-in Apply joint the sealing strip as shown in figure. D765 Push appliance into the housing until stop strip (A) touches the kitchen unit. A D022 If after having carried out the previously described operation there is still some space left between the appliance and the kitchen unit, fit the trimming provided together with the appliance on the stop strip (A).
Open the door and push the appliance against the side of the kitchen unit opposite to that of appliance hinges. Fasten the appliance with 4 screws provided in the kit included with the appliance. Snap vent grille (C) and hinge cover (D) into position. D C D727 Apply covers (B) on joint cover lugs and into hinge holes.
50mm Place guide (A) on the inside part of the furniture door, up and down as shown in the figure and mark the position of external holes. After having drilled holes, fix the guide with the screws supplied. A 20 m m PR166 Fix cover (C) on guide (A) until it clips into place. A C PR33 Open the appliance door and the furniture door at 90¡. Insert the small square (B) into guide (A). Put together the appliance door and the furniture door and mark the holes as indicated in the figure.
Should the lining up of the furniture door be necessary, use the clearance of slots. At the end of operations, it is necessary to check if the door of the furniture closes properly. PR168 Fix cover (D) on guide (B) until it clips into place. B D PR167/1 Prior to Initial StartÐUp ¥ Please clean the appliance interior and all accessories prior to initial start-up (see section: ÒCleaning and CareÓ).
ved (BS 1362) fuse must be used. Important! 1. 2. 3. 4. The wires in the mains lead are coloured in accordance with the following code: Green and Yellow Earth Blue Neutral Brown Live As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings indentifying the terminals in your plug, proceed as follows: The wire coloured green and yellow must be connected to the terminal marked with the letter ãEÒ or by the earth symbol or coloured green and yellow.
The green pilot lamp (D), which comes on when the mains voltage is available and the ON/OFF knob is pushed. Switch the temperature regulatore to a number position, the refrigerating unit automatically operates by system control. The temperature regulator (F), which can be used for continuously variable setting of the most energy saving storage temperature for your frozen food. The optimum storage conditons occur at -18¡C and can be +10 °C 0 checked at the thermometer -18 (fig.).
Starting up and temperature regulation Please clean the appliance interior and all accessories prior to starting the appliance. Plug in the appliance at the mains supply. ¥ Push the ON/OFF knob (E) The green lamp (D) comes on. ¥ Turn the temperature regulator (F) in the direction of ã1Ò. ¥ The red lamp (C) comes on, the audible warning sounds , and the refrigeration motor starts up. ¥ Operate the fast-freeze knob (A). The yellow pilot lamp (B) comes on and the audible warning stops.
der before freezing food. ¥ Please observe the freezing capacity given on the rating plate. The freezing capacity is the maximum quantity of fresh food that can be frozen within a period of 24 hours. If you wish to freeze food several days in a row, please observe a maximum capacity of only 2/3 to 3/4 of that on the rating plate. The quality of the food is best preserved when it is frozen right through to the core as quickly as possible. ¥ Allow warm food to cool down before freezing.
of the individual drawers, press the rider over the corresponding symbol (see "Frozen Food Symbols/Freezer Calendar" section). This will give you a better overview of the contents, avoid extended door opening and therefore save electricity. Preparation of Ice Cubes 1. Fill the ice cube tray 3/4 full with cold water, place it in the freezer compartment and leave to freeze. 2. To loosen the frozen cubes, either bend the ice cube tray or hold it under running water for a few seconds.
this operation it is not necessary to switch off the power supply or to remove the foodstuffs. However when the ice becomes very thick on the inner liner, complete defrosting should be carried out as follows: 1. Remove the frozen food from the freezer, wrap it in several layers of newspaper and put it in a very cool place. 2. Switch off the appliance and pull out the plug, or remove or unscrew the safety fuses. 3. Leave the freezer compartment door open. 4.
Cleaning and Care For hygienic reasons the appliance interior, including interior accessories, should be cleaned regularly. Warning! ¥ The appliance may not be connected to the mains during cleaning. Danger of electrical shock! Before cleaning switch the appliance offand rem ve the plug from the mains, or switch off or turn out the circuit breaker or fuse. ¥ Never clean the appliance with a steam cleaner.
Energy Saving Tips ¥ Do not install the appliance near cookers, radiators or other sources of warmth. High ambient temperatures cause longer, more frequent operation of the compressor. ¥ Ensure sufficient air circulation and exhaust at the appliance base and at the back wall of the appliance. Never cover air vent openings. ¥ Do not place warm foods into the appliance. Allow warm foods to cool first. ¥ Only leave door open as long as necessary. ¥ Do not set temperature any colder than necessary.
Malfunction Possible Cause Remedy Green light faulty. Please inform your customer service Yellow light faulty. Yellow light does not light up, when fast freeze fuction is activated, appliance is on. Please inform your customer service Green light does not light up, yellow light lights up when fast freeze fuction is activated, appliance is on. Appliance cools too much. Temperature is set too cold. Turn the temperature regulator to a warmer setting temporarily..
Malfunction Unusual noises. Possible Cause Remedy Appliance is not level. Readjust the feet. The appliance is touching the wall or other objects. Move the appliance slightly. A component, e.g. a pipe, If necessary, carefully bend on the rear of the appliance the component out of the is touching another part of way. the appliance or the wall. The compressor does not This is normal, no error has The compressor starts after start immediately after chan- occurred. a period of time.
Customer Service If you cannot find the remedy for a malfunction in these operating instructions, please contact your dealer or our customer service department. Addresses and telephone numbers are listed in the accompanying booklet "Guarantee Conditions/Customer Service Locations". Selective ordering of replacement parts can save unnecessary travel and costs.
AEG HausgerŠte GmbH Postfach 1036 D-90327 NŸrnberg http://www.aeg.hausgeraete.
